The output of the FDM-DUO is very clean, one of its many virtues. The specifications for the DUO-ART 120 state that "Output Harmonic / Spurious Distortion > 50 dBc in HF band" but I do not really

There's nothing special about the power LED on the S2--it's a standard blue through-hole LED. You can order a replacement from Digikey, Mouser, and many other suppliers.

Hi, I get best results by having SW2 AGC on medium setting, and listen through audio software that allows for filtering and emphazising of audio. When creating audio clips that I keep, I do the

Try adjusting the AGC threshold (move it to the left)

Hi again g0ofe About sdr console yes is a little soft as audio but in any case i tested s3 also with fdm-s2 software with the same results. If turn up volume i hear also more noise ... problably what

HI Sandro, Ah, so you're really comparing ColibriDDC software with Console and Elad SW2. It's a shame that Console doesnt support Colibri to enable you to get a direct

Hi g0ofe i hearing diffecences with AM and SAM modulation , compared to COlibriDDC . Is not simple to explain but in any case same station with same antenna is hearded different with the colibri . I

My S3 arrived last Friday and I've noticed no problems with the audio at all. Admittedly this is with Console as I don't use the native Elad software. To be honest, I can't

hi Guys I'm owner of an S3 and i'm not complete satisfy about audio clear Compared with other SDR i found still lower level audio . I tested with his sw and also with sdrconsole without difference. I

I add some information for completeness : - DUOr preselectors description can be found at section 3 of the User Manual, look carefully at the block diagram of the

My S2's power light LED has been out for some time. I'd like to fix it. I'm pretty good at the soldering station. Wondering if the repair is difficult in any way. I have yet to open the case, but

hey folks, i know it is bad form to perform necromancy and resurrect an old thread, but wanted to chime in for the record that 1) hal's info is correct; 2) despite no docs anywhere that i can find on

I would like to make the point clear. It is not TCP etc ... the real problem but only and only the fact that the Radio is not synchronized with the SW2. (see also the "Advanced Tuning" View) So any

Dear Vianney, You are not wrong! I got to give credit where credit's due. I apologize that I forgot to write that the TCP system with "Lock to CF" works. The RFRScanner program sends the frequency

Hello, here you can find the detailed TCP documentation : http://sdr.eladit.com/FDM-sw2%20Software/Doc/SW2_TCP_IP_Protocol/FDMSW2_TCP_PROTOCOL_v0_11.pdf I think you must first decide

Hello. We don't have a release date yet. Regards, Vianney Il 11/11/2020 18:49, Paul Jones ha scritto: Le informazioni

Hello Vianney, However, I would like to specify that SW2 in UNlocked state return the frequency to all devices using the TUNING BAND. ComPort, TCP, OmniRig, Receiver. Selecting a Frequency from the

Jim I intended to post it here: https://groups.io/g/UDXF/topics They have a lot of interesting and useful stuff there. For SWL utility monitoring, well worth subscribing to. Pete Slower

Pete. Sounds interesting. What group should you have posted to? Jim On 11/11/20 9:23 AM, Pete wrote:

Hi Sandro, The extio dll’s aren’t available yet, I don’t have a date when they will be. Vianney might chip in here with a date they may be available. Paul EladUSA