Merci Bernard. Le informazioni contenute in questo messaggio di posta elettronica sono riservate e confidenziali e ne è vietata la diffusione in qualunque modo eseguita (DL 196/2003). Qualora Lei

Test to see if I am still receiving group updates. 73 Clint W7KEC _._,_._,_

Impressive! However, I would like to have an inverted effect as a MW/AM DX listener. To the band-full of Trans-Atlantic signals, e.g. from Arizona! Seriously speaking, schematics of band-pass

Phase 1 of my 2 year HF Pre-Selector project is finally complete. The final step was to install the front panel label. My initial goal was to build a pre-selector that would prevent ADC overload on

I guess the team in Italy have an awful lot on their minds at the moment, raising a ticket is best so the request is recorded. Agreed, getting a marker in the right spot is very hard. I'd

On Thu, Mar 19, 2020 at 07:48 PM, Neil Smith G4DBN wrote: The scaling in the IF spectrum window should just reflect the FFT bin size change from 11.7Hz to 2.9HzThanks, Neil, it is as you say

Elad Discounts in Italy and USA Italy - Free Shipping on all items no code required at http://ecom.eladit.com/ USA - 5% Discount use promo Code CV5 at http://shop.elad-usa.com/ now until March 31st

I think it would be a great idea to put a firm proposal to Elad for some enhancements via the support ticket system. Give it a go. The scaling in the IF spectrum window should just

On Thu, Mar 19, 2020 at 03:45 PM, Klaus Brosche, DK3QN wrote: There is a brief description includingThanks for the suggestion, Klaus. A bit too ambitious for my low-level skills, unfortunately.

On Thu, Mar 19, 2020 at 01:16 PM, Clint Chron wrote: ADC overload is gone. :).

On Thu, Mar 19, 2020 at 01:02 PM, Clint Chron wrote: I suspect that there would not be enough demand for the special filters to warrant Elad’s financial investment in the project.I'm sure you're

Paul Jones, You are a star!

On Wed, Mar 18, 2020 at 10:51 PM, Neil Coley wrote: I’d do away with the S meter on sw2. Its obviously just decoration.Shite.

On Wed, Mar 18, 2020 at 11:30 PM, Neil Smith G4DBN wrote: Signal to noise ratio or relative signal levels are much more useful.So the SNR figure adjacent to S-Meter would be wonderful...

Thank you for your suggestions, Neil. I'll take these in reverse order. I'm not technical enough to write custom code or interpret FFT data, and anyway shouldn't need to for something as basic as

If you are 'ok' with a manually-tuned low-cost preselector, it might be worthwhile to have a look at the BCC (Bavarian Contest Club) preselector (design dated from ca. 1998). There is a brief

Hi Paul, This is a test to see if JPG pictures come through in an email on the groups.io site. Here is a spectrum display of the AM broadcast band at my QTH in Phoenix, AZ. I get ADC

Hi Paul White, I suspect that there would not be enough demand for the special filters to warrant Elad’s financial investment in the project. The current Elad ham band filters, while

Sounds like an opportunity for someone to design and make filter boards for other specific uses. I'd like a narrow one for 136kHz for example. Neil G4DBN

Paul I have requested a few months ago new filters to also cover the main broadcast bands that swl users can make use of. Also a dedicated am 520-1800 notch filter Paul EladUSA