Lower your drive and output will lower

Thank you Giovanni. Since nothing else was amiss and your email confirmed it, I then suspected a physical anomaly. Took appart the DB9 connector housing. Resoldered the wires and voilá, BLUDUO is

My DUO ART should arrive tomorrow. Is the output ALWAYS high or can the power output be lowered?? TIA Tom - M7MCQ

Hi All, just to point out that I have direct experience of the MFJ 1708B and it works fine!! In fact, I'd say it's one of MFJ's 'better made' products. You can read about my use of it HERE.

Hi Guillermo, the versions matches, so it is not problem with versions. So, powering the DUO, activating bluetooth on phone, verified that the adapter is paired and starting Blueduo should work (the

Hi Klaus, I have no HAM/CB operators nearby. As for my shack's 240V, it all runs through one socket which goes through this home-made FILTER.

Tom, What also came to my mind: do you have any sort of non-HAM or HAM transmitter close to your location? Opposite to your other transceivers, a

Tom, It makes no difference drawing the DUO power from the ART-120, as long as the power supply to the ART-120 is the same as before (same power source, the DC power

Hello Giovanni. FW versions on my DUO are: UI 0.487 FGA 02.00 USB 04.09 RX 01.50 TX 01.35 I installed the latest 2019-01-04 apk and got no response from the radio. No waterfall, no feedback on mode,

Okay, so I'm home and have tried the suggestions. Here's the answer to your comprehensive help Neil... What level in dBm does the display show with no antenna connected and with it

Don’t think I can help as traded in my ICOM 7300 to get an ELAD DUO-ART 120, because I found FDM-DUO’s Rx was much quieter than the 7300’s! As before, running with no RF ground - my current

Have you tried your LiPo battery in the shack to rule out noise from your power supply? I will ditto that of my radios the Duo is very quiet. Craig KA6RWL

Thanks for the replies so far - it's very much appreciated! I will try out some of the suggestions when I get home from work. The FDM DUO was purchased for use in the shack where a Yaesu FT-DX3000 and

You might want to check your AGC thresh-hold setting. If it is all way to the right, the radio will be very noisy. All the way to the left and the radio will be extremely quite. 73 Clint W7KEC

No they are not like that Tom. I use mine for extreme weak signal work on VHF/UHF/SHF and on LF and it is one of the best performers I have ever used. Hard to say what is wrong

Hello everybody. Of all my devices: KX-3, Xiegu G90, ALT-512 and FT-891, the ELAD FDM-DUO has the quietest receiver. With that I can hear the whole evening on my monitor speakers on the shortwave,

Hello Tom, Mine is *not* noisy at all. When yours was nice and quiet on the LiFePo: did you connect any antenna at that point? In the car: did you feed it

Hi all, I just bought a used FDM DUO and when I plugged it in last night at home, it was incredibly noisy!! I thought there was something wrong with my G5RV or with the existing settings in the

What DSP chip does it use? 73 Clint W7KEC

Hi Vianney, Is there a field(user)-installable upgrade option planned for converting an existing SP1 into SP1A? 73, Klaus, DK3QN Am