Hi Giovanni, when the powered USB hub is connected to the FDM-S2: does the FDM get power only from the USB HUB? How can I check this? I ask that because the USB power

Hi Paul, which program and which data speeed you used to program ? If not already done I suggest to use 38400 bps to program the dongle. In a previous message I posted a step-by-step guide (it could

Hi Willi, the easiest way is to use a powered USB HUB. Regards, Giovanni - HB9EIK

Paul, I had a similar experience trying to program up my HC-05. I twas very frustrating since following the instructions and the video to the letter did not produce any joy. I just could not get it

I either have the worst luck buying HC-05's... The bluetooth dongle is the last little bit I wanted to get done for my go box, it was a workaround for the lack of band buttons. I have tried four of

I would like to operate FDM-S2 on a tablet with external 5V power supply. For this I have to reduce the power consumption on the tablet. Is there a way to connect the FDM-S2 to an external 5V power

See the attached file for instructions to load, startup, and minimize VSPE on startup. Use shell:startup to open the startup folder. 73 de N4ENF - Pat

Right David! Now the registered Version "is somewhere" in a batch-file that sets up everything for ham-radio. Somehow 'fire-and-forget'. fyi: I am using my FDM-DUO completely on remote. I am

It's not really automated if you have to click twice every time. I paid the license specifically because I wanted an automated, unattended solution. 1 out of 500? That's awful. I tried DB-Buddy

hi David! you even can start it with a saved config without the key. always two extra clicks are needed. But surely it is always a question of fairness how long you 'test' a program before you pay

Stepan - Wolfgang is correct about VSPE. However, if you do use it unregistered, I don't think you can automate starting it with a saved configuration. With VSPE, you can save a configuration, then

Hello Tim, FYI regarding the Elad amp and tuner setup. It may take a while, but in the meant time. Take a look at my QRZ page KJ6YXI and you can see how I daisy chained my amps and tuner to get a QRP

Vianney - One more thing that really needs to be addressed in the next release is the function of memory tuning, which I reported about a week ago. If there are more than one receivers open, clicking

Vianney - That's great, but I cannot use version 3.002 because it consistently crashes when I use CAT control, which I need to use. I posted about this a few weeks ago, but didn't get any response

Neil - Thanks for the detailed response. Attached pics are the IF window and the spectrum at 6mHz with the adjusted spectrum slider (different band than last night). I also tried various different

Hi David, at 3072, the bin size is 187.5Hz instead of 11.7, and the FFT overlap does mean that adjacent bins get polluted by signals nearby, but not to the degree you are seeing. In

I have watched them and very helpful! Great product very impressed. I really purchased it since they had the hardware exposed. Lots of r &d went into this I see. Tim Air Conditioning by

Hello David, last FDM-SW2 version (3.002) should have a limit of 30 audio devices. We will increase this limit in the next release. Vianney Il 23/02/2018 00:06,

hi Stepan you can use the 64-bit Version without that key. It is only two clicks extra at start then everything is fine and works the same! I used it for a while this way before I bought that key. So

If logger32/N1MM support OmniRig, you can use that. OmniRig support is built into FDM-SW2. If they don't then you're probably stuck with VSPE. I use VSPE on Win 10 64-bit for the same purpose. It