Hi, I've just bought a Tmate v1 in a hamfair to use it with my FDM-S2 (with box, etc,..) but without software, after an small headhache I intalled the drivers in W10 and it works with FDM-S2 but I

A little extra info on the 60w amp...it seems the JA's can only run 50w when they go portable. They are looking for a good quality 50w amp. Franco's amp fits the bill very nicely. It also has an

Alberto, hurry up and put me on the list for the 120W version. 73 de Greg

Alberto, my apologies. It was after the witching hour of midnight, and Intelligam appears to have been prorogued! All is now OK. Robin, G8DQX On 18/09/17 14:59, Alberto

On 9/18/2017 1:20 AM, G8DQX wrote: Really ? I have just checked, and either reading the message with Thunderbird, as sent to my Inbox, or reading it via the Web

Not so much the quality but rather the quantity—there was no photo associated with the post! Robin, G8DQX On 17/09/17 21:40, Alberto I2PHD wrote:

On 9/17/2017 8:22 PM, Gregor Fischer wrote: It's a linear amplifier, born to be a companion for the Duo, not yet on the market, at least not until the end of next

On Fri, Sep 8, 2017 at 04:40 am, <vianney@...> wrote: DUO-ART amplifier.Can somebody tell me what is the " new DUO-ART amplifier"? 73 de Greg

Well...have you looked in Device Manager? Do you find the Elad entry? Does it say the driver came from Elad Italy? Just a suggestion...my two cents worth. Cal...W1HHO All the Best. From the woods

You tried the cascade trick which never works for me when the FM RDS goes off screen. Instead try this, move your mouse to the bottom Taskbar. Do you see FDM-SW2 running and can you hover your mouse

Hi John, FTDI chips are probably in your USB controllers, either on your MBoard or an add-on card, and it looks like Windows Update has trawled up an updated driver which may be incompatible with the

I am using W7-64 and last system update was 14 sept 2017... Plugged in my S2 and all works as it used to! Gotta be something else? Cheers Lasse SM5GLC 14 september 2017 19:51:57 +02:00, skrev John

John…if it's just the SCREEN that has disappeared this may solve the problem and return the Screen to the Monitor…. PRESS CTRL+ALT+R to reset the main windows to 0,0 x,y position of

Yesterday, Windows 7 performed an update, which included an "FTDI Chip" update. Something I had not seen before. After this update was installed, my Elad FDM-S2 refused to function. I used System

With large yagi antennas the S2 is very sensitive even in weak signal areas. With smaller antennas I too have found it rather poor as well. I don’t fully understand why this is but when using

I compare to a cheap $15 RTL 820T2 V3 dongle and SDR sharp and the S2 is rather poor for reception in comparison...I am quite disappointed and surprised at this considering the cost of the unit.

I should have mentioned that I use an W6LVP Amplified Receive-Only Magnetic Loop Antenna and I'm located in Delaware USA.

I've been monitoring Coast Guard ALE signals all day with my FDM-S2 without too many problems.

Yea, I really don't believe there is a problem in the radio, I have not been able to use the radio all day to listen to the ham bands or any utility frequencies it's just not going to work, I will see

The cable and connector are OK. Also I tried a discone antenna and long wire antenna. Steve On 2017-09-11 6:33 PM, Alberto I2PHD wrote: