Hi Group, Would like to see if one can setup the FDM-SW2 to control the Fldigi software. And also have the Fldigi control the SW2. FDM-SW2 setup: Remote Ctrl: 1) What CAT Mode to use? a.

All, Got it working. Thanks. Greg

Wow, didn't realise pa unit was going to give up access This just gets better all the time. I did look at expert electronics sdr pro2 ( currently on offer from Martin Lynch and co this weekend) but

It means that the PA will be the portal to connect your FDM-DUO from anywhere in which you can get on the internet. TRhis is more commonly called "remote control". It is what the world of K3, FLEX,

How?

When I try to connect a dxcluster I get connected to "login" When I sent my callsign I get as answer "PA3CDN is not a valid callsing" (On different Dxclusters I get the same message) It worked before

Group, How do I unlock / release the white tab button: Lock To CF under RX1? It is sticking and will not un-release by mouse clicking on the tab button. Comments welcome. Thanks, Greg

Of course I Murphy's law struck and about 10 minutes ago the jumping started after not seeing it here for quite some time. When I tune outside of FM (say 82 mhz) no jumping is noted. Checked around

I was copying some info from a CD to a USB thumb drive while the jumping was happening. Basically stopped after I finished copying. Tried it again and the jumping started. Switched out CD's and

Hi Is the Vers. 1.150? Look at https://groups.yahoo.com/neo/groups/elad_sdr_en/conversations/messages/11681 Regards Antonio

To all. Hope this will answer your question. Greg

Fixed the problem. Greg

Nice to see you solved it Keith, but that is definitely not the reason why this is happening here. I have to search further. Anyway, thanks for telling. 73, Guido.

First of all, don't mix up the product FDM-S2 with the product FDM-SW2 ... both are products from Elad, but they are two completely different things... It is unfortunate that Elad did

I have an FDM-S2 receiver that I like a lot. Now that I have my Amateur Radio licence, I'm ready to step up to an ELAD DUO. Once I've installed that, is there any reason to keep the FDM-S2 around?

The diagram in Annex A of the Software installation guide states to Mute the receiver connect pin 6 to ground pin 5. This has no effect on my S2, it does not mute so the RX box needs to be set to mute

Hello, All Goal to have Audio settings for the mic TX from one PC to Anther so as to move it over to my computer Elad SWR2 Given: Top Right corner of main screen has a person figure for

I have an ELAD FDM-S2 and a newly acquired ICOM ID5100A. I have them both tuned to 145.230 Mhz and I've manually switched the antenna (a Comet DS-150S Discone) between the two rigs. 145.230 is a

My S2 do work nicely on 2 meter. Have been listening to weak signals and beacons. So it sounds like you do have an issue with your radio. Just to make dead sure... you did switch antenna ports on the

Hi guys Just received my S2 back from Milan after Usb problem (Firmware). Now i cannot access any freqs as CF LOCK is highlighted.radio is set on 0Khz and i cannot see how to adjust.Any ideas? Aeneas