Hi all, x3 EDEN dsP V2.1 boards available for the cost of a stamp. Please message me if you would like one. 73, Ian MM0GYX

Hi All, I've been working on a receiver/exciter module to compliment the SPI Front Panel, although it will be suitable for use with the standard single and dual core Eden SDR software with some adapta

Hi, I was dusting the cobwebs off my EDENDSP v1, never transmitted from it, usually used it to listen on bands and compare reception reports etc. Just the other day, I had it on the table and was tink

Hi All, A belated "Wishing you Health and Happiness in 2023" with an additional wish that your embedded projects go well! During December I had little time to work on the SPI Panel project but I manag

Now sorted Ron. Can play it with VLC in linux. Display is unusual, but very usable. Well done and thanks. 73 Vin G4ksy

Hi All, Following a busy summer and a couple of long road trips into Europe I've returned to the issue of adding a spectrum display to the Eden SDR software. This is the incurable itch; it won't go aw

Can anyone recommend an alternative now there web site is closed? Oracle / Matlab is a possibility but a steep learning curve. Thank you John Knott 2E0KNJ

This may be of interest to those who like the minimalist approach. It's also a useful technique to potentially get onto the low VHF bands (6m and 4m here in the UK) using direct conversion schemes. As

Can the KiCAD files be shared ? de VU2UPX

This may be of interest to those who enjoy tinkering. I'm building a front panel in which all of the controls (except the display) share a fast SPI bus. The goal is to reduce the menu levels of the or

Hi Ron I have hooked up the Eden board to the Veteran SDR and all the functions seem to be working. the codec I haven't checked as of yet. I used 1.11.240 pack XC16 2.0 I also changed all of the refer

I have two bare eden dsp boards version 2.0. I have already built the boards I need so these are up for grabs. If you want one let me know Clarence,NT7V

On 29.650 now, access tone 71.9Hz, Tx on 29.550 Regards Ron

That's the easy bit done, I'm way out of my depth for the rest. I have a pickit 2 and understand I'm not using the standard pickit software, rather mplab ide. I'm looking around the files trying to fi

Hi Ron I updated the IDE and synced the settings and the problem rectified itself all is working , thks very much for the work your doing. Ron VE3LBG

Hi Ron Also in the main.c line 45 message can not find LED_secondary.h line 93 message can not resolve LED_secondary tks Ron VE3LBG

Hi Ron: I've just built up an EDN board V2.1 and i'm using MPLABX IDE 5.45, loaded the files according to your instructions (PDF). have the LED_main and LED_source installed as a main and slave, When

I have built several, and studied many DSP based receiver back ends. Designers go to a lot of trouble to generate I and Q signals by using a clock stream and one or two JK flipflops, or an LC hybrid t

Hi folks, I heard about this group recently, I have done quite a bit of SMD work before and built several kits, including Genesis G11, mcHF etc. but, I'm not knowledgable when it comes to coding etc.

Hello and welcome to the Eden DSP group! Over the coming days/weeks I will be building a structure in the "files" section within which to place hardware and software designs for the Eden DSP module. I