anybody ??

i've got the DXlabs dxview config address and port defined , as shown on the arco screen...   port 4001 ( not active ! )

enabled at startup ...checked ....running yaesu protocol gs-232


ideas ??

Thanks to Josef for getting me squared away   works as expected ....GREAT

+ AA6YQ comments below

Thanks to Josef for getting me squared away works as expected ....GREAT

+ Your post prompted me to review

https://www.dxlabsuite.com/dxlabwiki/RotatorControl

+ and discover that I had not updated it to include "microHAM ARCO" in the "Rotator-specific Information" section; I have now done so. If additional information would have helped you, Bill, please let me know.

+ I also discovered that with the ARCO panel set to TCP, clicking the Serial button does not make the "Serial Port Interface" panel appear, as it should; this defect is corrected in the next version of DXView.

73,

Dave, AA6YQ