Date
1 - 4 of 4
Rotor control using ARCO with Orion
|
Joe Subich, W4TV
ARCO needs an IP address, Port and Control Protocol specified
toggle quoted message
Show quoted text
on the Settings -> LAN tab. If using IP, DXView Rotator Control tab needs the IP Address and Port in the ARCO box and either Arco Hygain or Arco Yaesu in the Model box. Hy-Gain/Yaesu should match the "Control Protocol" specified in Arco's Setup -> LAN tab. 73, ... Joe, W4TV
On 2022-08-09 5:52 PM, bill steffey NY9H wrote:
HI Dave, |
|
|
|
i see i used hygain to talk to the rt21,,,,,,
thanks
On 8/9/2022 6:05 PM, Dave AA6YQ wrote:
+ AA6YQ comments below |
|
|
|
Dave AA6YQ
+ AA6YQ comments below
Great to find a box marked ARCO. + The OR2800 rotator controller does not use either the Hygain protocol or the Yaesu protocol. ...then stick the arco IP address in the tcp host address box ???+ When controlling an ARCO via TCP, you must specify both the Host Address and the Port in the ARCO panel on the Rotator tab of DXView's Configuration window. 73, Dave, AA6YQ |
|
|
|
HI Dave,
Great to find a box marked ARCO. Since it is controlling an ORION2800 , and previously was a Green Heron RT21 ( Hygain I think).. I'm thinking I should check ARCO HIGAIN ...then stick the arco IP address in the tcp host address box ??? wireless hahaha bill |
|
|