Hi everyone Would appreciate some help please. I have Commander setup to work with Thetis SDR software using TCP/IP. Works very well, no problems.
I am starting to experiment with Vara AC using the Vara HF modem software. Vara AC will only connect via COM ports so i have configured Commander to use the Secondary CAT serial port and have used both Kenwood and FlexRadio protocol as I can select either of these in Vara AC. I have frequency changes working correctly so i know the com port connection is working. However i cannot get PTT working at all and am stumped on what to try next.
I can get Vara AC working correctly by connecting directly by Serial CAT to Thetis so i know Vara AC CAT is ok. My preference however is to have all my CAT control going via Commander so i can use the command scripting etc.
Would appreciate some help please. I have Commander setup to work with Thetis SDR software using TCP/IP. Works very well, no problems.
I am starting to experiment with Vara AC using the Vara HF modem software. Vara AC will only connect via COM ports so i have configured Commander to use the Secondary CAT serial port and have used both Kenwood and FlexRadio protocol as I can select either of these in Vara AC. I have frequency changes working correctly so i know the com port connection is working. However i cannot get PTT working at all and am stumped on what to try next.
I can get Vara AC working correctly by connecting directly by Serial CAT to Thetis so i know Vara AC CAT is ok. My preference however is to have all my CAT control going via Commander so i can use the command scripting etc
+ Commander does not provide the ability to switch its Secondary CAT port between RX and TX. The Secondary port is intended to support connection to a second radio that tracks the primary radio's frequency (for diversity reception), a panadaptor that tracks the primary radio's frequency, or an external device like an amplifier, tuner, or antenna switch that tracks the primary radio's frequency.
