AA6YQ comments below
-----Original Message-----
From: dxlab@... [mailto:dxlab@...]On Behalf Of
Jim Shaw
Sent: Tuesday, April 17, 2012 11:48 PM
To: dxlab@...
Subject: [dxlab] PropView Your Station Location & date
In the 'Your Station' panel, my Lat. & Long. Info default is always wrong.
Correct values are Lat 41 48 N Long 81 54' W. PV defaults to 41 29' S 81
54' E. I have the correct values in my QTH selected in DK.. When I enter
the correct value, PV keeps resetting it when I go back and forth between
Parameters and Prediction tabs. Where do I go to set the default properly?
If you have DXView installed, PropView refers to the QTH information
specified in the QTH panel on the General tab of DXView's Configuration
window.
When trying to determine propagation at a future date, I set the target
date in the Conditions panel, but PV keeps resetting it back to the current
date. How can I get PV to leave my date alone?
Uncheck the "Show Current Time" box at the bottom of the Main window's
Prediction tab.
73,
Dave, AA6YQ
