Joe - Thanks for that info. I started putting a slash in the zero when writing numerals about 50 years ago. Thus when I began computer logging I wanted a slashed zero font and could not find one. Abou

Jim - On the Log tab of the DXK Config page go down to the Log Page Display section, select Fonts there and then select T93Y. I am sorry I forgot when I sent my earlier email that I had set it in both

Dave - I sure like a slashed zero font in DXK and here is how I got it: Go to the Config tab in DXK, then select Log, and just below halfway down the page, at the far right "Log Panels" find the Fonts

Dave - Clicking RUN, as you suggest, yields the same result... but, a local just called me, and this was a case of that pesky "window off the screen" issue. I was able to maximize it to get it onto th

Earlier today when I opened DXL a window popped up telling me there was a new config file for TQSL (V11.10). It also told me my Certificate would expire in a little under 2 months. It gave me the opti

John - I installed DXK 15.4.9 shortly after it became available. I am not seeing the behavior you are describing, but I don't recall seeing it in 15.4.8 either. I know that may not help you, except pe

Thank God Dave is very good at chess. Dave - K9FN

Mike - I am so glad you sent that You Tube... last summer my car was in the shop because it was running a bit roughly, but only sometimes. They ended up replacing the engine... thank goodness it was u

Rod - I think I am near the end of my short list of ideas... but here are two more things to look at: 1: Make sure the dates under the LoTW sync buttons are the dates on which you invoked those sync a

Rod - You say you have completed the sync process... but did you sync both LoTW QSOs AND LoTW QSLs? If you only synced LoTW QSOs I believe you would see the results you have. GL de Dave - K9FN

Dave - In safe mode the behavior was what I expected. I rebooted (out of safe mode) and tried again... now it is again behaving normally. I do wonder if I have failed to correctly configure MS Defende

This afternoon I am seeing something that I don't believe was happening in the past. About 90 minutes ago I worked VP2VB before taking a break for lunch. When I came back to the rig the "arrow" at the

Mike - That is almost funny, because all my CW contacts are logged with a white background, but my sole FT8 QSO has a yellow background. Dave - K9FN

Steve - Thanks for the response... N9FN confirmed the same to me on Saturday morning, and as you probably saw, AA6YQ did as well... I had never noticed that before. Take care and 73 de Dave - K9FN

Is it normal for the slider at the right edge of the SC display to alternate from the bottom of the page to the top and back again every few seconds? I have just noticed that behavior for the first ti

Dave - Many thanks for the prompt reply. I admit that I never considered that I may not have actually double-clicked. I do have peripheral neuropathy, so I don't get reliable feed back from my fingers

A short while ago I saw a friend spotted on 17 meters, and double-clicked on his call. A few minutes ago I saw a friend spotted on 20 meters. I double-clicked the spot and the radio went to that frequ

And the multitudes said AMEN!!! Dave - K9FN

Andy - All of the local DXers are using DXLab. We all started elsewhere, and would never consider going back. After a brief discussion, we figure that if you had still been using something else you wo

Julio - I did see your original message abouit an hour ago... so it made it to the list. No doubt Dave will respond when he gets time. Dave - K9FN