In connecting my TS-990 to a computer I had problems with both FTDI and Prolific chipsets. The problem was solved by following the recommendation of: Leo Fahmie KJ6HI DM03 Amateur Radio Technical Supp

I have a similar setup. Connecting the Green Heron to the computer with a DB (I forget the exact name) rather than a USB fixed the problem. 73, Steve K2SN Sent from BlueMail

Thank you for this information, Dave. I worked TX7T, and the grid info showed on DXV, but didn't carry over to DXK. A quick copy and paste solved the problem. Thanks again for your great software, gre

Yes, "grid 1" is flashing in blue. Sent from BlueMail

Since the recent increment to 15.2.4, the award panel checks into the on position all by itself, when not intended. Has anyone else noticed this? 73, Steve K2SN Sent from BlueMail

Thank you, Dave. 73, Steve K2SN Sent from BlueMail

Yes, I am using the bridge with the auto-connect option checked. Starting CWS and then Commander always works. Sent from BlueMail

When Commander is running and CWSkimmer is then started, CWS shows freq 000. If Commander is then closed and restarted, CWS correctly shows the transceiver frequency. What am I doing wrong? Sent from

Compared with Rachmaninoff, CW seems trivial. All the best, Dave. 73, Steve K2SN Sent from BlueMail

On FT8 my RX is set for a bandwidth of 5000 Hz. Reception tapers off near the extremes. Few signals are anywhere near the high end, but some are at or below 200. In those cases, it helps to tune down

The TS-990 has provision for time setting with digital control codes : https://www.kenwood.com/i/products/info/amateur/pdf/ts990_pc_command_e_rev1.pdf

You don't have to terminate all of DXLab when you power down, just turn off Commander. That's what I do and it works fine. 73, Steve K2SN Sent from BlueMail

The correct port setting for W9PA-5 (FT8 skimmer) is 7374. 73, Steve K2SN

Thank you for considering this, Dave. 73, Steve K2SN Sent from BlueMail

Would it be possible to include a column for SPProb in the Spot Collector Webserver report? The QSO probability generated by PropView 1.9.4 is very useful information. 73, Steve K2SN

I had tp terminate and restart both Commander and WW, and now I see the 13.8.0 and WW does show the new labels. Sorry for the confusion. Thank you very much, you have been a real friend. 73, Steve K2S

Thank you, Dave, for Commander 12.4.8. It works well with the TS-990. I'm unsure of your meaning that Commander conveys the Data-U information to WW. On the WW config/general tab the operating mode se

YES WW TO SWITCH TO PSK 31.

I use TS-990, which has USB-D1 through D3 and the same for LSB. Sent from BlueMail

Thank you, Joe. I didn't know that. Very useful info. 73, Steve K2SN Sent from BlueMail