The proposal is that each state be treated in DXView as a virtual entity, with the Progress chart showing results for that state rather than for all of the U.S. When enabled, each state would have the

My thought is that DXView could treat each state as though it were an entity and display progress for each mode and band for that individual state, just as it does now for Alaska and Hawaii. The chart

My suggestion is that DXView for, as an example, Alabama, could display the same way it does for Alaska. Perhaps this feature could be toggled on or off. 73, Steve K2SN Sent from BlueMail

Modifying DXView to show each U.S. state as an entity, the way Alaska and Hawaii already show, would help those working toward WAS band awards. The emphasis of DXLab is, of course, on DX, but this add

The Spot collector email alarm is very helpful. When SC is restarted, for example after an update of databases, the alarm is no longer enabled, the enable box is no longer checked. Does anyone else ex

Right clicking on a new DXKeeper entry and selecting upload to LotW results in feedback showing the task is in progress and then done. Selecting upload to Club Log produces no feedback, such as does o

In connecting my TS-990 to a computer I had problems with both FTDI and Prolific chipsets. The problem was solved by following the recommendation of: Leo Fahmie KJ6HI DM03 Amateur Radio Technical Supp

I have a similar setup. Connecting the Green Heron to the computer with a DB (I forget the exact name) rather than a USB fixed the problem. 73, Steve K2SN Sent from BlueMail

Thank you for this information, Dave. I worked TX7T, and the grid info showed on DXV, but didn't carry over to DXK. A quick copy and paste solved the problem. Thanks again for your great software, gre

Yes, "grid 1" is flashing in blue. Sent from BlueMail

Since the recent increment to 15.2.4, the award panel checks into the on position all by itself, when not intended. Has anyone else noticed this? 73, Steve K2SN Sent from BlueMail

Thank you, Dave. 73, Steve K2SN Sent from BlueMail

Yes, I am using the bridge with the auto-connect option checked. Starting CWS and then Commander always works. Sent from BlueMail

When Commander is running and CWSkimmer is then started, CWS shows freq 000. If Commander is then closed and restarted, CWS correctly shows the transceiver frequency. What am I doing wrong? Sent from

Compared with Rachmaninoff, CW seems trivial. All the best, Dave. 73, Steve K2SN Sent from BlueMail

On FT8 my RX is set for a bandwidth of 5000 Hz. Reception tapers off near the extremes. Few signals are anywhere near the high end, but some are at or below 200. In those cases, it helps to tune down

The TS-990 has provision for time setting with digital control codes : https://www.kenwood.com/i/products/info/amateur/pdf/ts990_pc_command_e_rev1.pdf

You don't have to terminate all of DXLab when you power down, just turn off Commander. That's what I do and it works fine. 73, Steve K2SN Sent from BlueMail

The correct port setting for W9PA-5 (FT8 skimmer) is 7374. 73, Steve K2SN

Thank you for considering this, Dave. 73, Steve K2SN Sent from BlueMail