I have the same setup, except for RTS in Commander/Port. Mine is set to Off and works OK. 73 de Knut LA9RY Den 27.04.2020 01.31, skrev Jim:

+ AA6YQ comments below + On the General tab of Commander's Configuration window, there's a PTT panel in the middle. Please uncheck this panel's "suppress CAT" box, if it's checked. Find a clear

There was no check in the box labeled suppress CAT and when I press TX it transmits and when I press RX it goes back to receive

+ AA6YQ comments below Ok I have updated the IC7300 firmware and the com ports are now stable and can be left for at least a week without turning themselves off. The last problem I have (and I

Thanks Dave,  that did the trick... Mike

Ok I have updated the IC7300 firmware and the com ports are now stable and can be left for at least a week without turning themselves off. The last problem I have (and I created it) is when I transmit

+ AA6YQ comments below If I don't want to use the Windows default browser for DXLab help, do I have to specify the alternate browser's pathname separately in each DXLab application's configuration

+ AA6YQ comments below tnx Steve that you answered me, I have a VSPE vitroual port emulator working perfectly with Commander and JTDX if Interrogation is disabled by Config-General.if closed

+ AA6YQ comments below Thank you for your quick reply. To answer your question is no - I don't see any Grid square. I tried <compute> on that but came back null. + If a QSO specifies a grid

If I don't want to use the Windows default browser for DXLab help, do I have to specify the alternate browser's pathname separately in each DXLab application's configuration panel, or can it be set in

tnx Steve that you answered me, I have a VSPE vitroual port emulator working perfectly with Commander and JTDX if Interrogation is disabled by Config-General.if closed Commander and start.

Thanks for the quick reply Dave. There is no delay when using the TX/RX buttons in the Config dialog of Commander with Split enabled. I will post this to the WSJT-X forum. -- 73, Matt, N0EYE

Dave, Thank you for your quick reply. To answer your question is no - I don't see any Grid square. I tried <compute> on that but came back null. Mike

+ AA6YQ comments below I'm having the same issue with my IC-7300 using Split mode in WSJT-X. Also getting about a 2-3s delay switching to transmit. I'm using the "Fake It" option in WSJT-X for

I'm having the same issue with my IC-7300 using Split mode in WSJT-X. Also getting about a 2-3s delay switching to transmit. I'm using the "Fake It" option in WSJT-X for now. I can provide a debug log

+ AA6YQ comments below

I have no doubt. For my needs, I do a lot of different types of filtering at the cluster level and I hadn't run into the need to send ascii codes...yet. Thanks for the history. 73, Matt W1PY

+ AA6YQ comments below In the "Initial Cluster command", < and > are used to set of a specific ASCII character. For example, <13><10> sends CRLF (Return, Enter). See the Spot Collector Help file +

Thanks for pointing me in the right direction Joe! 'SET DX FILTER SPOTTER <60><62> K2PO/7' does the trick. 73, Matt W1PY

I thought the immediate upload feature of DXK was fantastic when I first used it. After a few weeks I noticed two things: 1. It more often than I found acceptable encountered problems with LoTW site