Hi again, Just checked the version of TQSL, and it is showing as v2.5.3 and when I check DXKeeper - Config, QSL Config, loTW tab, that is showing TQSL v2.5.2. Oops! I needed to close DXKeeper,

Hi all, After the SPDX RTTY contest at the weekend, I started DXKeeper, I was informed that there was a new TQSL Config file, which I installed. I then successfully uploaded my log fro within DXKeeper

No. As Dave has indicated previously, to do so would require changing the "commands" feature into a full blown programming language and command interpreter for every supported transceiver. With 128

Hi Dave & the group, Got an issue that can be quite easily illustrated via "snippets" (custom capture of windows screen

Is there a way to get Commander to read the slider values from the rig? For example, if I change the power level with my slider the rig tracks fine to the slider value (within 1%), but if I change

DTR and RTS should both be set to off. 73. Carl -WC4H

I have the same setup, except for RTS in Commander/Port. Mine is set to Off and works OK. 73 de Knut LA9RY Den 27.04.2020 01.31, skrev Jim:

+ AA6YQ comments below + On the General tab of Commander's Configuration window, there's a PTT panel in the middle. Please uncheck this panel's "suppress CAT" box, if it's checked. Find a clear

There was no check in the box labeled suppress CAT and when I press TX it transmits and when I press RX it goes back to receive

+ AA6YQ comments below Ok I have updated the IC7300 firmware and the com ports are now stable and can be left for at least a week without turning themselves off. The last problem I have (and I

Thanks Dave,  that did the trick... Mike

Ok I have updated the IC7300 firmware and the com ports are now stable and can be left for at least a week without turning themselves off. The last problem I have (and I created it) is when I transmit

+ AA6YQ comments below If I don't want to use the Windows default browser for DXLab help, do I have to specify the alternate browser's pathname separately in each DXLab application's configuration

+ AA6YQ comments below tnx Steve that you answered me, I have a VSPE vitroual port emulator working perfectly with Commander and JTDX if Interrogation is disabled by Config-General.if closed

+ AA6YQ comments below Thank you for your quick reply. To answer your question is no - I don't see any Grid square. I tried <compute> on that but came back null. + If a QSO specifies a grid

If I don't want to use the Windows default browser for DXLab help, do I have to specify the alternate browser's pathname separately in each DXLab application's configuration panel, or can it be set in

tnx Steve that you answered me, I have a VSPE vitroual port emulator working perfectly with Commander and JTDX if Interrogation is disabled by Config-General.if closed Commander and start.

Thanks for the quick reply Dave. There is no delay when using the TX/RX buttons in the Config dialog of Commander with Split enabled. I will post this to the WSJT-X forum. -- 73, Matt, N0EYE

Dave, Thank you for your quick reply. To answer your question is no - I don't see any Grid square. I tried <compute> on that but came back null. Mike

+ AA6YQ comments below I'm having the same issue with my IC-7300 using Split mode in WSJT-X. Also getting about a 2-3s delay switching to transmit. I'm using the "Fake It" option in WSJT-X for