CW and SSB have entries in Spotcollector's "Sub-band Definition" file. Unless you have modified your definition file or downloaded an update, FT8 and other "new" modes will not be properly identified

Bill, Thanks but I am still a bit confused as this only occurs with FT8 spots. I never have had an issue with SSB or CW QSOs displaying the proper mode in the SPotcollector "Mode" column. Paul

No. SpotCollector does not provide a cluster compatible port for other applications. 73, ... Joe, W4TV

Hi Paul, the contents of a DX Cluster spot do not include any mode field, either the notes must contain an unambiguous reference to the mode, or in the case of SpotCollector you must have a sub-bands

Occasionally I will spot QSOs in Spotcollector but recently I spotted two FT8 QSOs and one showed up as RTTY and the other as CW when both were FT8. I right-clicked each time on Each of the QSOs and

Is there any way to use the filtered resulting spots in SpotCollector as a spot source for N1MM? Pete, W1RM W1RM@...

No error logs but I'll know what to look for next time. Thanks!

If I suppress the CAT commands, the rig won't go into transmit either. I unchecked the "suppress" option and did a cold re-boot of the computer. Now, the rig goes into transmit and receive as it

There are no errors reported in Event Viewer - just some ESENT warnings (Apparently a bug in Windows) and DCOM warnings (Inherent to Windows program) which only occur at startup. Otherwise

+ AA6YQ comments below Thanks Dave, I was looking for a reason to buy a WinKey - now I have one! Their website promises a replacement for the K44 keyer/reader by mid-September. I think I'll hold off

Thanks Dave, I was looking for a reason to buy a WinKey - now I have one! Their website promises a replacement for the K44 keyer/reader by mid-September. I think I'll hold off and see what it looks

+ AA6YQ comments below Dave AA6YQ, Just a question please, on Commander 2nd CAT protocol and selection features, I refer to the 'Flexradio' 2nd CAT profile selection for use with the SPE

+ AA6YQ comments below Thanks for analyzing the errorlog file Dave. Are there any work arounds that would allow sending CW messages longer than 60 characters with the IC-7300? + Sure: use a

Dave AA6YQ, Just a question please, on Commander 2nd CAT protocol and selection features, I refer to the 'Flexradio' 2nd CAT profile selection for use with the SPE amplifier; Does commander support

+ AA6YQ comments below I've been having some trouble with PTT running FT8 (latest version). The PTT method is CAT control with the rig as DXLab Commander. My physical rig is a K3S. The "Test PTT"

+ AA6YQ comments below "Configuring Spot Collector In the WSJT-X panel on the Configuration window's Spot Sources tab Check the Enable box; if WSJT-X is running, the right-most LED-like display in

Thanks for analyzing the errorlog file Dave. Are there any work arounds that would allow sending CW messages longer than 60 characters with the IC-7300? The IC-7300 has 8 CW keyer memories, each of

I've been having some trouble with PTT running FT8 (latest version). The PTT method is CAT control with the rig as DXLab Commander. My physical rig is a K3S. The "Test PTT" works. When operating,

"Configuring Spot Collector In the WSJT-X panel on the Configuration window's Spot Sources tabCheck the Enable box; if WSJT-X is running, the right-most LED-like display in the Spot source status

+ AA6YQ comments below The errorlog.txt file is attached. + Thanks, Andy. Analysis of your errorlog shows that WinWarbler directed Commander to transmit an 81 character message via your IC-7300's