Dave, % When DXView starts, it recovers the state of the Enable box in the Translations panel on the Configuration window's General tab from the Window Registry. If the Enable box is checked, the

The lifetime parameters were different. That must have been the issue.

+ AA6YQ comments below + As a next step, I suggest that you invoke this function: https://www.dxlabsuite.com/dxlabwiki/IdentifyDXCCCreditDiscrepancies 73, Dave, AA6YQ

+ AA6YQ comments below + There are no gremlins; just things we don't yet understand. 73, Dave, AA6YQ

I am cleaning up my 26K+ database. I ran all the options in Check Progress and cleaned up a lot of Q's. Most of my band-mode slots are V's now, but I have about 400 QSOs from 1982 to 2017 which are

Dave, I did a submittal again today and did not see that problem. It turns out that I was not in the VU4W log so I had to delete the contact anyway. A LoTW "Add Requested" worked fine with a few new

# more AA6YQ comments below I actually had two thoughts going when I responded to the post Dave. As I was typing the "YES" response it dawned on me that being able to return the first copy command

+ AA6YQ comments below I notice that sometimes a spot will appear on the Waterfall display but is not in the list in SpotCatcher (which is filtered). The Commander Config Bandspread Tab has the

% more AA6YQ comments below + The last DXView upgrade was more than 4 weeks ago, and made no change to the Translation functionality. # While that may be the case Dave, The Translation window did

+ AA6YQ comments below Actually the IF command response from SDR Console contains the frequency set for VFO A plus the status (mode set, split, etc). I thought the digits after VFO A frequency was

Hi Dave. Actually the IF command response from SDR Console contains the frequency set for VFO A plus the status (mode set, split, etc). I thought the digits after VFO A frequency was the VFO B

That was it. Thanks Joe, appreciate it 73 Marty W8AKS

Callsigns ending in -# as the source are "Skimmers" You can not prevent them from spotting your callsign. However, if you do not want to see spots from skimmers you can: 1) enable prefiltering

A while back there was a thread regarding a checkbox to stop your call from being spotted on the Ft. Joe W4TV posted the how to message but I’ve lost it Can some refresh this okd mem bank. It had

I am thoroughly enjoying DXLab. I notice that sometimes a spot will appear on the Waterfall display but is not in the list in SpotCatcher (which is filtered). The Commander Config Bandspread Tab has

+ The last DXView upgrade was more than 4 weeks ago, and made no change to the Translation functionality. # While that may be the case Dave, The Translation window did not launch at startup until a

When I look at mine, I have sent Y and RCVD R

+ AA6YQ comments below + OK. With no other applications but Commander running, is there a specific set of actions that you're taking that cause the unexpected change in VFO B? 73,

" Does this behavior occur when you are only running DXLab applications?" Yes, but I seldom use the PC with other applications. Mostly Firefox and YouTube, and no problems with these so far.

+ AA6YQ comments below + So that I can see what's going on, please place your log file (suffix .mdb) in a zip archive, attach the zip archive to an email message, and send the message to me via aa6yq