Im sure Dave will answer, but you are alwlays gonig to see that, as its a pip on the screen at LOTW, and they havent fixed it. It is simply the last one that was uploaded for you there, and will

For as long as I can remember, ever time I check for new QSL's on LOTW I have at least "1 new QSL". Tonight, I did a check. I checked for new QSL's 5 times right in a row, and every time I had a new

oh yea - very clever Dave! THAT's why YOU make the BIG bucks! thanks, Tom

I accomplished remote CW by having WinWarbler do the CW generation (controlled via LogMeIn) and listening the the received CW via Skype. 73, Dave, AA6YQ for you. I've not accomplished

rr - I use Skype for remote operation - SSB. If you want to do remote CW, Marty, Skype isn't going to get it for you. I've not accomplished remote CW. best of luck, tom

I don't think so. Auto may mean "Automatically turn the on-board card off the there is an installed card." I would set it to "On" if that is an option. 73, Tom, W3TMC

Dave, As usual, cockpit problems is the answer - you are right I did not run the RECOMP and now that I have all is correct. It also found a few errors (mostly time ending issues) which have been

Hi Dave - Whenever I started Commander, I was getting an error message to the effect that the Filter Group file wasn't found, and the default was being used. I tried to select a different file, and

Many thanks gentlemen (Firebrick and Dave) Problem fixed and it appears I did not lose any information Thanks Again, John

Hi Ron, I had the same problem with one of my older dell computers. As soon as I put an internal PCI sound card in, I could no longer access the on board sound card. I searched all through the BIOS

Welcome to DXLab, John! I don't think you've lost any information. You can add or remove columns to the "Log Page Display" shown at the bottom of the Main window's "Log QSOs" tab. To do so, open the

No to both. It literally went away as if it no longer exists. Someone suggested check in the bios setup and onboard audio is set to auto, which I believe means that the device is being initialized. It

Go to DXK's configure option (just above the log listing) Select the Log tab. the Log Page Display (near the bottom) gives you the options to add/modify which fields you wish to see.

I am new to DXLab programs. I used Winwarbler for a few weeks then decided to inmport my Logger32 files. Before importing Logger32 files I was able to see all the fields in DXKeeper "Log QSOs"

http://www.idiompress.com/ They work GREAT!!! Jose - N1BAA Darryl Kwasny wrote:

You have the current DXCC database (2.2.2) installed, but it sounds like you did not perform a recompute operation on your current log after installing this version of the DXCC database. The Recomp is

Does anyone know if there is a RS 232 interface available for rotors without one such as CDE Ham-M or Ham-4 rotors? They use a 500 ohm pot. I found one doing a search but it is just a list of

Hi Dave, Problem solved. I had an error message that I didn't notice. I cleared up the problem and everything is fine. 73 Art W2NRA "Keep to the Code!" w2nra.com

use sound add in Ron: Go to Control Panel and select Sounds and Audio Devices. On the drop down, select the Audio tab and see if the motherboard sound card is listed. If so select it! When you

Hi Dave, I am having an inconsistency in window height when I click on a spot in SpotCollector. This has happened a couple of times now. The latest is I clicked on a 20m CW spot for S7/K9NW and the