Dave: On one hand I understand your decision to leave in the ad space because of the cheap "bas*****rds" who won't pay the nominal QRZ license fee, BUT on the other hand, why should those of us who

Sorry Dave Just now getting to appling your suggestion. I followed the instructions but am not seeing the Distance in the Details panel under Log QSO’s. I went to ADVANCED SORTS, FILTERS AND

+ AA6YQ comments below Ok, Dave & Neil, thank you very much for the good advice. Maybe an old dog can learn a few new tricks after all. So at this point, I think I'm going to do a couple of

Ok, Dave & Neil, thank you very much for the good advice. Maybe an old dog can learn a few new tricks after all. So at this point, I think I'm going to do a couple of things. 1. Check the priveleges

Thank you, Dave. This helps me a lot. @ Joe: I know as well as you do that as of today no award will accept PDFs or whatever else of digital print outs. But I am very sure that within the next 10 - 15

Joe- tnx for suggestions, I was not updating Workspaces after making the changes. 73 Paul w2eck

+ AA6YQ comments below + There is not. 73, Dave, AA6YQ

On Mon, Sep 5, 2022 at 09:12 AM, Gary Smetana wrote: All is working well, except getting a very slow response, when DXView is ON: Case #1 DXkeeper & Pathfinder both ON. DXView OFF.

+ AA6YQ comments below The QSL cards and labels that DXKeeper generates QSL are utilitarian, optimized for soliciting a confirmation at the lowest cost. If you need more flexibility in the cards and

I spent a couple of hours last night trying to enter several contacts in DXKeeper and almost beat my head against the wall. Why? 7228 is NOT a 40 meter frequency in DXKeeper. 7.228 IS. This tripped me

Hello Dave & the group from W1EBM, After a long QRX with health issues, I'm QRV & getting the Radio Desktop PC back up and running. A Dell Sr. Technician came to my home & installed a new Hard Drive &

Are you using the MultiRadio tab in Commander? Are you using Workspaces and loading one at start-up? Have you updated both of those after changing the port? 73, ... Joe, W4TV

I am trying to change the com port number I had previously used with a radio in DXCommander. So I go in to config and change the port number but the change does not persist. When I reopen config- it

Not anyone interested in awards since e-mail (pdf) "cards" are not acceptable for most legitimate awards. The few e-mail "cards" I get go in the trash and the sender goes on my "lid" list

Thank you, Dave, for pointing me in the right direction. 73, Steve K2SN

Hello, I am using the print cards feature of DXKeeper to insert the qso information in a picture which I "print" as PDF with MS print to PDF as printer. The "card" is sent via email (I don't want to

I prefer to use FSK because I don't have to worry about getting the audio drive level correct. I still see many problems with audio drive not being set correctly and causing splatter,

+ AA6YQ comments below + Why would you prefer to not use AFSK? 73, Dave, AA6YQ

Dave,    Ok, but I can not use the same rtty mode for my two radios, one is remote and has to be AFSK, the other is local and should be FSK, I can switch it to AFSK (the K3) but would prefer not

+ AA6YQ comments below Radio 1 (K3) has its rtty mode set to FSK Radio 2 (K4) has its rtty mode set to AFSK I'm still getting the error listed below, I double checked the radio settings and the