Hi Joe. I am using a workspace, and that thought crossed my mind as well. I have updated the W9ISF workspace a couple of times after setting the default message. Doing so had no change in the

Ken, Are you loading a workspace at startup? If so, is the default QSL message stored in that workspace (did you update the workspace after setting the default QSL message)? 73, ... Joe, W4TV

Good morning, Dave. I have recently stumbled onto an issue that may or may not be a problem. With the annual special event that I host, I always have the default QSL Message set up in DXKeeper with

ARCO needs an IP address, Port and Control Protocol specified on the Settings -> LAN tab. If using IP, DXView Rotator Control tab needs the IP Address and Port in the ARCO box and either Arco Hygain

i see i used hygain to talk to the rt21,,,,,, thanks On 8/9/2022 6:05 PM, Dave AA6YQ wrote:

+ AA6YQ comments below + The OR2800 rotator controller does not use either the Hygain protocol or the Yaesu protocol. + When controlling an ARCO via TCP, you must specify both the Host Address and

HI Dave, Great to find a box marked ARCO. Since it is controlling an ORION2800 , and previously was a Green Heron RT21 ( Hygain I think)..  I'm thinking I should check ARCO HIGAIN   ...then stick

+ AA6YQ comments below + Attachments are not conveyed here. Please attach your errorlog.txt file to an email message, and send the message to me via aa6yq (at) ambersoft.com 73,

Dave, Here's the errorlog file. Thanks. Tom NR8Z

+ AA6YQ comments below + Is there an errorlog.txt file in your SpotCollector folder? If so, please attach this file to an email message, and send the message to me via aa6yq (at) ambersoft.com

When I click on the "Need" filter button on SpotCollector the listing goes blank even though there were highlighted entries that I need. When I click on the "X" button to clear the filter none of the

Thanks for sending me your errorlog, Chip. The entry 07-Aug-2022 19:41:21 > program error 285 in module PSKMinilog.LogQSO, State = 89: Foreign application won't perform DDE method or

+ AA6YQ comments below Although I do not own an RF2K I have checked the available information some time ago. An english manual is available at

I have a question ... RFKIT & Commander work fine . However this thread has me checking my settings...   commander indeed is set to 12060  for  127.0.0.1 AND rfkit also 12060 to xxx.183 Also

You will also need to provide the IP address of the RF2K, 127.0.0.1 is the "loopback" address on the PC running Commander and will not reach an external device. 73, ... Joe, W4TV

Although I do not own an RF2K I have checked the available information some time ago. An english manual is available at https://rf-kit.de/files/User_Manual_RF2K-S_ENG_V14.pdf

+ AA6YQ comments below + I went looking for documentation that would explain how the RF2K implements "CAT data through IP (UDP)" - but found none. + Port 52002 is what Commander utilizes to

I am looking to config my rf2k amp to commander. I have been in network service in commander. i have ip address of 127.0.0.1 and port 52002. in rf2k udp port window I have 52002 and listening to

# more AA6YQ comments below Thanks for your response, Dave. The error log is attached. # Attachments are not conveyed here. Please attach the errorlog.txt file to an email message, and send the

Thanks for your response, Dave. The error log is attached. When I hit the 'log' button, it does not clear the fields in the log panel. I have manually clicked the 'start' and 'end' qso buttons. I