Hey Paul I’m not at pc right now but I think I remember a setting in spotcollector’s Config panel that lets you adjust the frequency of updating the window. Just a thought. Jeff WB9DAR

Thanks but, no, I have not “clicked” on a call. I can start Spotcollector, leave the shack and come back sometime later and it has locked up and the red “Autoscroll” is flashing.

you must have clicked in the window on a call, this stops the scrolling obviously or it would be scrolling off the page.

Check the time on the top of the Spot Collector Window as compared to the time on your computer. I'm betting you are 1 hour ahead of what SC says it is. Question - How to sync the two Mark W1MAW

Changed my PC clock to match the tome stamp on the top of SpotCollector and now spots are being displayed. So it is an issue with where SpotCollector sets its time... How does that get set? Mark W1MAW

Having the same issue. Interesting that the time logged in the error message is for 1 hour behind the actual time. I am sure that has something to do with the spots not being shown. question is...

I am receiving this message and the application will not display spots even though each of the sources (windows) show spots being collected. Any suggestions? Thank you. Error being displayed in Error

Imported from N1MM and not sure how many dupes as as soon as it get the error it stops....

Spotcollector always starts fine but, after a 15 to 20 minutes, it “locks up” and “Autoscroll” flashes in the upper right, often in red but occasionally black. Clcking on it returns all to

Are these QSOs made using DXKeeper/WinWarbler or contest QSOs made with a different logging program and imported? Were they uploaded from other software before importing to DxKeeper? How many QSOs

From within dxkeeper.....it adds them to the que, then it signs them, then tries to upload and that's when I get the error...

Start here: http://www.dxlabsuite.com/dxlabwiki/DebugUnacceptedLotW 73, ~iain / N6ML

Define your QTH in the my QTHs tab of DXKeeper. Then click the Config button to open the Log tab of DXKeeper's Configuration. Here you can set the default myQTH ID (in the Log Settings panel) 73, Mike

Hi to all! How can I change “default myQTH ID” in DXKeeper Configuration Logpage? 73! Igor, UC6N

Hi to all! With way can I change “default myQTH ID” in DXKeeperConfiguration Log page? 73! Igor, UC6N

I tried the IC7610 group with no response, so I thought I would try this group. Here is the problem. Since Icom uses it's own driver for the IC7610 com ports, I've downloaded and installed that

tQSL thinks that some have been. How are you generating your upload? 73, ... Joe, W4TV

getting an error about duplicate qsos, but these qsos have not been uploaded yet.

Good evening all, I'm not sure if this question has been addressed before - if so, my apologies. My XYL is using DXKeeper, and has discovered that a large number of her QSOs before mid-2017 which were

Hello volker First i send this to dave and the DXLab group so Can you help me with this ? Volker I have star Spotcollecot alone there was no problem so I have start FLDigi no problem CwSkimmer no