none

None of those. I’m Just Sayin’ 73 de K3JAE John

Joe, Here are WSJTX instructions. If your radio is keying then I have to think Commander is working but you are not getting audio from

Joe, Did you look here? http://www.dxlabsuite.com/dxlabwiki/TranceiverControlYaesu ----------------- 73, Tom - KQ5S

None, Mike, N5SJ From: dxlab@... [mailto:dxlab@...] Sent: Thursday, December 28, 2017 3:04 PM To: dxlab@... Subject: Re: [dxlab] New poll for dxlab None

Dave, When I upload an adi file to DXLab’s DX Keeper the location for myQTH is blank and is sending a painful bell to remind me to add the location. Is there a way to default this setting? In my

Dave, Would you be able to send me the link for specifically setting up a Yaesu FT991 with Commander? I assume some of my settings have changed. When I test CAT, the button turns green, and when I

Found the problem - took a total re-install of Commander. It was a Windows Defender issue. Apparently, when you run Commander first time, you should get asked if it can be allowed to access

Hi Dave - Many thanks for your continued effort in keeping DXLab going so well throughout 2017. Thanks to DXLab many of my DXing objectives continue to be accomplished. Fantastic! All the best

under DXKeeper Configuration, Log, Log Page Display, is 'Indicate LotW & eQSL AG status' unchecked? -- Jeff KC9WSJ <jeff@...>

Bruce, I have my 7300 setup using a virtual port splitter in Windows for my USB connection. I went the port splitter route, since I wanted to continue to use FSK RTTY. I have mine setup to use DXLabs

<dxlab@...> wrote: Hmm. It should open a window entitled "Network Service". Check if there's an icon for it on your Taskbar. If so,

There is a DXLab "Radio" listed in the WSJT-X config box. This is supposed to handle the issues you just mentioned. At the moment, I can't get this function to work (even though the equivalent "Radio"

Clicking on the Net Serv button does nothing on my version. No new dialog pops up, and there is no change. I never changed any defaults on that, so perhaps the whole net serv process is not going. By

Jim, I made the switch from HRD to DXLab last year. I had 70K qso's to synch up. Turns out you just need to let it sit for while. The error I received is the Windows time out

You may want to review this anyway ... http://www.dxlabsuite.com/dxlabwiki/ResetMarathonAwardTracking 73, ~iain / N6ML <dxlab@...> wrote:

From decades before I began using DX Labs, I have a long DXCC history. I have looked up the DXCC "compare" function on DX Keeper, and it gives me the list of entities confirmed and the ones that don't

Hi Dave, did you rcvd e-mail with attached ErrorLog.zip sent 28th Dic ? 73 Giuseppe, IT9FGA

Please disregard – recalculate solved the problem. Thanks & Happy New Year. Ed, K5EK

In the Check Progress Configuration Panel I changed the year to 2018 and the spreadsheet to point to the 2018-1 spreadsheet. To check I tried to generate a submission and get a message that indicates