Good morning, Dave. I have recently stumbled onto an issue that may or may
not be a problem. With the annual special event that I host, I always have
the default QSL Message set up in DXKeeper with "Thanks from W9ISF!". I
have noticed this year that when I start DXKeeper, after logging a QSO, the
QSL message is blank. I need to go to the "Defaults" tab in "Config" and
select my message in order for it to show up once again. Once I do this, it
will continue to automatically fill until I terminate DXKeeper and re-start
it. I don't recall having to select this for every operating session in the
past. If this is normal behavior, then that's fine. I just wanted to point
it out in case it's not.
Thanks as usual,
Ken, KJ9B