Re: WinWarbler Deja Vu


Dave AA6YQ
 

+ AA6YQ comments below
Same problem here. Cycled through all com ports searching for PTT.  Switched K3S from VOX to PTT. Cannot key rig from WW..

+ There are 3 ways for WinWarbler to switch a K3 between RX and TX:

1. configure WinWarbler to use a serial port modem control signal that drives a level-conversion interface connected to the K3's "SEND" input

2. configure Commander to use a serial port modem control signal that drives a level-conversion interface connected to the K3's "SEND" input, and configure WinWarbler to use Commander for RX-TX switching

3. configure Commander to send CAT commands to the K3 for RX-TX switching, , and configure WinWarbler to use Commander for RX-TX switching

+ See "Switching a Transceiver between Reception and Transmission" in

https://www.dxlabsuite.com/dxlabwiki/PTTMechanism

 

73,

        Dave, AA6YQ

 

 

 

 

Join DXLab@groups.io to automatically receive all group messages.