Re: Powering down K3 using DXLab Commander


iain macdonnell - N6ML
 

On Fri, Feb 12, 2021 at 11:46 AM David Reed <w5sv.dave@gmail.com> wrote:

I need some help figuring this out; I can do the power down from the Elecraft Utility (using command "PS0;")

In trying to get it to run from Commander, I have done the following (but no results); other than this, Commander is working fine.

User -defined Command Sequence:
Note: Power Off
Command: PS0;
Try the following:

'PS0;

ASCII commands must be prefixed with a single-quote - see
https://www.dxlabsuite.com/commander/Help/CommandSequences.htm

73,

~iain / N6ML

Join DXLab@groups.io to automatically receive all group messages.