- DX Commander with an IC-7300 and SDR Console
Re: DX Commander with an IC-7300 and SDR Console
toggle quoted messageShow quoted text
Tnx on Skimmer tip, that will keep him busy.
On Fri, Feb 5, 2021 at 3:24 PM Joe Subich, W4TV <lists@...
Since SDR Console V3 uses Omni-Rig for transceiver interfacing,
the information in
should be directly applicable with SDR Console V3 replacing HDSDR.
Specific configuration of SDR Console V3 is left as an exercise
for the student. Omni-Rig is probably best configured to control
a Kenwood TS-2000, Commander's Secondary CAT serial set for Kenwood
CAT Protocol and "Follow & lead primary", and SDR Console configured
for the Kenwood transceiver. Icom protocol may work as well but
there is an added complexity of the correct CI-V address and the
Kenwood protocol is a bit more "full featured" in this application.
... Joe, W4TV
On 2021-02-05 3:51 PM, Hasan Schiers N0AN wrote:
> A buddy of mine, KB7IJ would like to run DXC with his SDR Console V3
> software. Is that possible?
> He wants to use the 7300 on TX and use the
> SDR for Rx ..and he has the 7300 SDR port mod installed.
> I referred him to this:
> But he said it made no mention of SDR Console v3...so it wouldn't work?
> Something about ports or virtual ports. I'd like to put you two
> together, but don't want to even start it if it's not possible.
> 73, N0AN
Join DXLab@groups.io to automatically receive all group messages.