Re: Commander not recognizing Kenwood TS-440SAT


Joe Subich, W4TV
 

do you have the RTS/CTS flow control options set correctly?
microHAM USB Interface II does not pass RTS/CTS. The radio RTS
line is held high ("always on") by the hardware. The UART RTS
and DTR "outputs" are used for PTT and CW respectively.

In Commander one would set DTR to None (PC Generated CW is not
available with Commander) and set RTS to "X" (use for PTT).

In WSJT-X one would set DTR to None and use RTS on the same
COM port as CAT (but preferably not CAT commands). Without
looking at "File -> Settings" Handshake should be "none",
PTT Method = RTS and Port should be the same as "Serial Port"
in CAT Control.

73,

... Joe, W4TV


On 2020-06-15 1:09 PM, g4wjs wrote:
On 15/06/2020 14:58, Steve wrote:
MicroHAM USB Interface II is operating correctly, but Commander does not reflect the radio frequency, or anything else. Any suggestions?

Thanks,
Steve W1LV
Hi Steve,
do you have the RTS/CTS flow control options set correctly?

Join DXLab@groups.io to automatically receive all group messages.