+ AA6YQ comments below

I've seen this as well and have wondered if I had WinWarbler mis-configured. I'm sure I've missed something.

I just performed Dave's suggested procedure and do not have AZ in the QSO info pane populated.

+ With DXView running, please do the following:

1. on the General tab of WinWarbler's Configuration window, check the "Log debugging info" box

2. terminate WinWarbler

3. start WinWarbler

4. enter my callsign in WinWarbler's QSO Info panel, and strike the Tab or Enter key

5. wait 10 seconds

6. on the General tab of WinWarbler's Configuration window, uncheck the "Log debugging info" box

7. attach the errorlog.txt file from your WinWarbler folder to an email message, and send the message to me via

aa6yq (at) ambersoft.com

73,

Dave,