Re: DXKeeper new capture window.

Ron Eberson <zx@...>
 

it's use the paralel port as the printer.
I can send you the program


-----Oorspronkelijk bericht-----
Van: Dave Bernstein [mailto:dhb@...]
Verzonden: dinsdag 20 maart 2001 22:12
Aan: dxlab@...
Onderwerp: [dxlab] Re: DXKeeper new capture window.


If there's documentation for the RS232 command set, then yes its
possible. I checked the web site but didn't see this documentation.
If you have it, please forward me a copy.

73,

Dave, AA6YQ

--- In dxlab@y..., "Ron Eberson" <zx@c...> wrote:
Yep thats good

Is't posible to use the modem and software for EA4TX rotor control?

see http://www,ea4tx.com

this is not a comurcial bud i run this and like it.

Ron
PA1ZX

-----Oorspronkelijk bericht-----
Van: Richard B Drake [mailto:rich@w...]
Verzonden: dinsdag 20 maart 2001 18:46
Aan: dxlab@y...
Onderwerp: [dxlab] DXKeeper new capture window.


Dave,

I have been trying the new capture window and like it very much.
This morning, I got the run time error from CI-V commander without
WinWarbler running. What I had open was CI-V commander, DXKeeper
(with the new capture window) and DXview. One small change of
frequency from the radio dial and up came the error. It's not
consistent though, I can't reproduce it at will.

-----
73, Rich - W3ZJ
www.w3zj.com



To unsubscribe from this group, send an email to:
dxlab-unsubscribe@y...



Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/



To unsubscribe from this group, send an email to:
dxlab-unsubscribe@...



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Join DXLab@groups.io to automatically receive all group messages.