Would any of you have the contact piece that fits in the top of the steering shaft? It is the contact part that grounds the horn. .........................Jim.

This sedan is an early 49 with mech brakes, the car runs, drives, and stops. The car is yellow with a driver quality paint job. The interior is decent. $6,500 the car is located in Indiana and has a c

Silly request guys. I need one (1) "ball top" piece that screws on the wiper control, coming up through the dash. It is on my '47 pickup with vacuum wipers. .....Jim.

In a haul of parts. I got what looks like a decent bare tin block. I filled it up with a 10:1 solution of water to molasses(works just like evaporust, but much cheaper-and slower). So far not one drip

Here is Dave Z. the pinstriper hand painting my logo on my new shop truck. He has been pinstriping my cars for years. ......Jim.

evenin' Jim, Spock, Dave, et al.... There has been enough inquiry about the Prewar that I'm putting up for sale that maybe posting an honest appraisal might help. Plus a few more photos. Its a 1940 Cr

Mornin' Jim et al... Say..I'm going to be putting my '40 convertible sedan up for sale. I'd certainly prefer that it go to another true Crosley enthusiast. Where is the best place to list it? If this

President Dave posted on Facebook that another long term Ohio member has passed. Below is Dave’s comments. Larry was along time friend and a moderator on the Crosley-Gang for years. “I was just inform

Here is the September CotM, enjoy. http://crosleyautoclub.com/ Jim...

Did the factory receive the wheels painted black from the supplier & then they painted only the face (red or white), like Studebaker did? Or did they paint the whole wheel?

Just saw this message from President Dave on the club Facebook page. “I didnt see it posted anywhere, so I will post it. I have been informed of the passing of long time club member and good friend De

I came home today with a small truck load of Crosley stuff. The guy at one time had over 10 of these cars. Wound up getting : One COBRA , two cast motors, a trans & rear end with mechanical drums. Num

I have a 1947 Round Side that I am restoring and I need some help with ID'ing the paint. The previous owner had the body media blasted and then covered it with grey primer and a scattershot burgundy t

Ok, I'm stumped. My voltage regulator doesn't have any markings on the connection points. I can't figure out how to wire it up. I don't want to let the smoke out. Can anyone tell me which wires go on

If my 52 wagon sits long enough that the carburetor runs dry, I can't get the fuel pump to fill the carburetor bowl. The starter motor doesn't spin fast enough for it to pump fuel. Is this a sign that

Forwarding for Laura Alexander of the West Coast Crosley Region. --------------------------------------------- Hi Everyone! PLEASE NOTE: HAVING OUR MEET DEPENDS ON THE COVID STATUS OF OUTDOOR/INDOOR G

I owe Dale, Service Motors an apology. What I should have said was that he was out of stock, but tanks were coming. They have supplied most of my parts for the 2 cars I'm working on. Good service, goo

Does anyone out there have a new gas tank they will part with. Service Motors is out of stock. .......Jim.

I have a headliner concept that results in a great looking car but is not impossible to do if anyone is interested. If requested, I can describe it in detail.

Robert Cunningham has written a great article on The Old Motor web site on Crosley's racing highlights. https://theoldmotor.com/?p=186269&fbclid=IwAR3rAc6tjpVCDr2GLOhzMbY9M1W-l5KwOxYElbTTfE0J-0_xMu6E2