I bought this wagon for my dad about 10 years ago it was complete and prob would run and drive as it was. He was pretty excited and took it all apart and had it dipped. It has very little rust and I f

I'm working on a 48 Pick Up. .Although the engine was a good runner, I replaced it with a fresh rebuild. I also replaced the working clutch & Pressure plate with new ones but left in place the old thr

I was thinking of doing an engine swap in my 50 sedan but don't really want to get into building a new frame. I was thinking a gm 2.2 4cyl from a s10 pickup keeping the efi and the 5spd manual trans.

Hello All.. I am putting my engine back together (‘51 Super Sports) and while setting the distributor I noticed the book shows a seal (see photo #13) that sits on the distributor side of the drive gea

Is the crankshaft on the right steel or nodular? Trying to determine whether either of these is not just cast iron.

Can anyone tell me what Crosley used to secure the wiring harness in place, how many and where? Thanks P.S. I have had issues replying to items on this board, so if you ask me a question and I don't r

Thought I would pass this along. Vc for sale in Florida on Craigslist. It’s a bit of a project. I contacted the seller a couple weeks ago he does have the windshield frame. Was previously listed for $

If this is posted in the wrong section please remove. i have a 1960 crofton bug that I'm replacing the drivetrain on. So the old motor and trans needs to go. The trans is original to the   bug and s

Just picked this up today a old homemade crosley snowmobile,guy said he got it from out behind a old barn were it sat maybe 20+ years. Its crosley drive train and frame right up to the trans mount the

Stay Warm http://crosleyautoclub.com/index.html

At a recent local car show I had a gentleman come up to me and ask me if I’d be interested in a Crosley Generator….I now own it. I primarily wanted to keep it from being scrapped and would like to kno

I got a kick out of these and thought Id share... Sommerset, Pa Ice Festival

I've been a member of the Crosley Club for a few years (#5980) and attended the National Meet this summer for the first time. I own '51 Pickup and live in Arizona. I grew up in Ohio and went to ballga

Wondering if anyone recognizes this little tag. Maybe rear differential? thanks...

I keep seeing a message that my access is still pending approval. Thought I would try a test message. Thanks, Mike Saltsgaver Hella Electronics Corporation, 43811 Plymouth Oaks Blvd., 48170, Plymouth

A member spotted this ad and I'm just passing it along. I know nothing about them or the seller. They are suppose to be in running condition. They would require a lot of work to convert them to car en

Jim, a smooth case Sprite transmission is not worth installing. It has NO synchro in first gear, and with a small engine, you will be going there OFTEN Dave Perry OldSchool Restorations North Alabama

Is there a trick or tricks to making sure the idle tube and the lower needle actually line up ie: the tip of the needle actually goes into the end of the idle tube ? I got a new tube and it's dead str

For an H Mod project I found a Sprite smooth case trans after several folks suggested this as a good alternative to what I was looking at. I know this has been done and need to find out the procedure

> > I am looking for photos of brake plumbing from master cyl. to splitter to torque tube. > Trying to reassemble a basket case 1951 CD panel. > Thx. > Sandy Smith > Arkell ON Canada > > Sent from my