More questions on Crosley wheels. Do the FORs use the same wheel as the other Crosley cars? Is there a longer lug nut for the rear dual wheels?

I updated the vendor page to add a couple of new vendors, update a few, remove some that went away and to make it more smartphone and tablet friendly for people viewing it on mobile devices. If you se

I went through my collection of Crosley wheels and noticed that a few of them are wider than the standard Crosley wheel. The standard Crosley wheel looks to be 4 inches wide, and some of my wheels are

Here is the October CotM. Hope you enjoy the flash back. http://crosleyautoclub.com/ Jim...

I am desperately looking for a Crosmobile front emblem and 4 Crosmobile hubcaps to finish my Super Sport restoration. Can anyone help me out? I also need a hood and new interior, or patterns to have

NOT MY CAR - this was posted on the "Crosley - Fun Little Cars" page over on FaceBook. After messaging the poster, I'm helping her out by listing it her. I can't answer questions about the car, so ple

A friend sent me this link to a YouTube video. The first half is an antique tool flea market which is how he ran across it, but starting around the 5 minute point is a walking tour of the IL Regional

Sent to me with a phone number 507 822 0557 ask for Todd - looks interesting, but home built. He is unsure of value

CrosleyKook has posted another interesting article on his blog, check it out.https://crosleykook.blogspot.com/2020/09/the-crosley-super-sports-coupe.html Jim...

I updated the web page I made for the tractor project. For those that haven't seen earlier posts this is a project my Dad started in the 80s and never got finished after having a series of strokes. I

I have a pile of water pump cores and am getting ready to rebuild a few. I've done a large number of three or four bolt water pumps in the past, but never a six bolt. Is there any special trick to the

Getting back to the project of making some reproduction flywheel covers. Got the front half pattern fine tuned (making 2 at a time) & just need to fine tune the back half pattern. The originals are a

What, if any, should the clearance be from the outer face of the rear main bearing to the crankshaft counter weight. I have a new set of bearings and when you lay the crankshaft in the crankcase and t

I have some ideas on this problem but want to seek the advice of the Crosley collective. Last weekend at the Illinois Meet we did our small cruise. Nice and slow, a little stop and go. When we returne

Which one of these four early compact cars would you choose for your Dream Garage?Asking the question would you rather have a Batam, Crosley, Metropolitan or King Midget https://www.hemmings.com/stori

I can't be the only person to have this problem. When I open the hood on my 48 CC the support rod slides into place like it should to hold the hood up. In about a minute the rod slides back and the ho

Dan Strohl wrote another interesting story that ended up leading to the Taylor engine and Crosley. Even referenced our Crosley Family Tree pages.https://www.hemmings.com/stories/2020/09/17/why-didnt-h

I'm cleaning up the interior roof of my '48 wagon. I noticed that there is a place in the corner above the windshield where a sun visor could be mounted. Did Crosleys have sun visors inside? If so are

_._,_

Someone recently posted a photo of an engine block, wondering who had made it, but it seems to have vanished from my inbox. *Matt Tritt* 14160 El Camino Real Atascadero, California 93422 805 466 6825