Re: Looking for help getting `48 wagon running for Nationals. Located in Toledo Ohio area



On the carb, grind a wrench down AND remove the cam/valve cover.

On the distributor, you must FIRST remove the oil pan and take the gear off of the distributor, before it can be removed from the crankcase. The distributor drive gear will NOT pass thru the crankcase hole.

Personally, I would not disturb the oil pan yet. Most likely you have rope seals, and they are a BEAR to install, in the car, and have them not leak.

If you take the carb off, modified screwdrivers are required, to disassemble it without damage to the jets and carb body.

Have you gotten your service manual yet. If not, the tow projects that you are attempting, are leading you into some dangerous territory.


On 6/4/2019 6:12 PM, Todd Swangstu via Groups.Io wrote:
So I stopped out at the 48 today just to get an idea if where I am at with it.?? As mentioned I have never touched the car before, bought it and she went in winter storage.?? So here is what I found out and some questions.

-It is a cast iron block, installed the new 6V battery.?? Headlights work, dimmer works, dash ammeter works, horn works.
-Has an electric fuel pump mounted where the original went.?? There is power to the f-p but the pump itself is DEAD.
- power to the coil and to the dizzy but constant power at ground side of the dizzy..., points open and close fine I am guessing the condenser is probably bad.
-Starter turns over super strong and powerful.
-90% sure the coolant leak was from the hose leading from top of the radiator to the block.?? It has a heater spliced in and seemed to be leaking there and down around block.?? Went to fill radiator and it was only low to that point the block was still full of coolant which made me quite happy.

So, I decided to yank the carb and dizzy and take em home with me clean em up do points and rebuild the carb.?? It is a Tilitson.?? So here are my first newbie questions for ya'll
-What is best way to remove the carb??? the outer bolt was a breeze the inner one was near impossible.?? I am guessing you need to either remove the entire exhaust and intake manifold to gain access to that nut or perhaps the valve cover and grind down a 7/16 to fit in the tight spot....Tips, Tricks?
-Distributor, I removed the mounting bolt and the dizzy was nice and free. It will raise up about 2-3 inches then catches on something inside the block.?? I did not want to force it so figured I would ask here FIRST.?? Is the dizzy removable from the top or do you have to get at it from below??? Just thought I would yank it for easier clean up-tune up install.?? Again any tips etc.
-Fuel pump, should I go back to the old manual one or find an electric again?

Was pretty happy and findings today.??
Thanks for help


Join to automatically receive all group messages.