1. Crosley-Gang@groups.io

Re: 3D Printing Radio Knobs????

Jim Bollman
 

The red ones were reproduced back in the 80s in small quantities by making a mold from a good original and pouring plastic of some sort into the molds. I had a set of them and they were very nice. Person that did them died about 20 years ago, not sure where the molds went.

Jim...

On Mar 20, 2019, at 11:45 AM, Mike S <miso7@...> wrote:

[Edited Message Follows]

Were there more designs than these 2?  Which was more common?  Is the shaft the knobs go onto "D" shaped or do they have the slot for a metal strip in the back of the knob?  Were the original knobs die cast or plastic?
Mike S <Knob one.JPG><Knob philco.JPG>
Join Crosley-Gang@groups.io to automatically receive all group messages.