Re: New Gas Tank Doesn't For Properly


Be aware that early CC gas tanks are not the same as CD gas tanks.


From: [] On Behalf Of David Reina via Groups.Io
Sent: Tuesday, August 14, 2018 4:33 PM
Subject: Re: [Crosley-Gang] New Gas Tank Doesn't For Properly


Hey Gang,


I also bought one of these new stainless steel tanks for my 47 Sedan.  I was excited about getting it for my car.  Its a real pretty thing with nice looking welds but it didn’t fit my car.  Of course you don’t discover this until you take down the original one.  In the 47 car the tank is held up with two straps which attach to fixed bolts coming down from the floor sheetmetal.  The new tank had tabs with didn’t line up with the fixed bolts.  I thought, well OK I’ll just use the old straps but the filler neck location on the new tank was welded in closer to the centerline of the tank.  Positioning that filler neck through the big hole for it in the floorboard made the tank sit too far to the driver side, enough so that the passenger side strap was past the end of the new tank.


Another thing to note is that the fuel pickup line comes out on the front side of the tank rather than the original position on the side of the tank.  That fuel pickup line on the new tanks is a 3/8” outside diameter tube rather  than the original threaded hole.  Thats OK but since we are joining it to 1/4” steel line why not make it the same size.


I’m being critical but for such a good idea as a tank that will never rust why not follow the original style more closely so we don’t have to improvise installing them.


Dale was gracious about letting me return it and I also sent back a carefully cut piece of plywood showing the exact bolt location as well as the filler neck hole on my floorboard.  I don’t think there is anything unusual about my 47 and hopefully he can use that pattern to straighten out his welding shop.


In the end I was lucky to find a shop in Queens that could still boil out and seal my old tank.


Dave Reina

Brooklyn, NY

47 Sedan

51 Super Sport



On Aug 14, 2018, at 12:05 PM, crosleyshortsport <crosleyshortsport@...> wrote:


The filler tube is a tough job to get into the floor and side panel and to line up with the tank and get the copper breather tube in correctly. Just installed this one two weeks ago, had my daughter help, and it took an hour total ! The filler tube does come very tight to the cross member. You will have a much easier time of it if you egg shape the strap holes.  Jeffrey


On Tue, Aug 14, 2018, 11:48 AM crosleyshortsport <crosleyshortsport@...> wrote:

I have bought three of that same tank.  On two of them I needed to egg shape the holes on the straps to get them to work. The third on fit perfectly.   Jeffrey


On Tue, Aug 14, 2018, 11:25 AM Spock Arnold via Groups.Io <> wrote:

Contact the vendor you bought it from


On Aug 14, 2018 11:16 AM, Jane Altman <bchjane@...> wrote:

Ordered the new stainless steel gas tank.  It is not fitting as the old one did.  Dropped old tank to put new one in and it does for the same.  The welded brackets, straps, don't match up to the original boots.  Bolts are square headed 3/8.  We redrilled and tried to install but the filler pipe was too long and fits right where the cross member is.  
Any install advice??






Join to automatically receive all group messages.