Scissor lifts should only be used on dead level paved surfaces. They are totally unstable and deadly on soft or sloped surfaces. A bucket truck operator might be possible to find. Boom lifts inmy

i believe a bucket truck is better than a scissor lift ... On 4/1/2021 10:06 PM, Herb Celler wrote: This email has been checked for viruses by Avast antivirus

My 51 is on sawhorses at present, ready to be moved to a new location on the property. I'll got out and get the info on the cables for you and email that and some pics if

The wd0m web page says he is trying to figure out how to replace the hand crank with a drill using an adapter. See the

Thanks Don. It does to a certain extent. This one I picked up has two cables severely rusted with one going from the winch around the top pulley and then attached and the second attached at the top

Rent yourself a 60 foot hydraulic lift . That's what I did.Try United rental they are Nation wide

A good friend of mine is a Ham who lives in Wimberly, just south of Austin, Texas. He is former President of the Collins Collectors Association and has an incredible display of Collins gear. He has a

Herb - snow is gone for one more time! I concur with Frank on my TMM541SS - 2 in x 4 inch vertical tube 85-5/8 long - fixture bottom to bottom hole, 41-1/8, mid 43-3/16, top hole 46-3/16 (using

See if this attachment helps. I have one also. Don W7WLL On 3/31/2021 5:12 PM, jecrowley157@... wrote:

Recently purchased a WT-51 and am needing to replace the raising cable. I have new cable but am unsure as how to route it. Anyone with a diagram would be most appreciated. TYIA

I see...I thought maybe it had something to do with the cable spooling up on the drum and they mounted it that way instead of flat on the tower.an over a little for handle clearance....?

Dave: The only reason that I can see is why you wouldn't mount it flat on the tower is the clearance from the handle to either the mounting plate or tower cross members. Your knuckles would be getting

Understood....why couldn't you just mount it like they do on the us 438 or the older triex or hy gains....flat and off to the side ?..I know that some the hand crank bracket was welded to the

I’m looking for a 1-200Ω Digital Clamp on Ground Earth Resistance Meter. If you have one for sale please contact me offline --- adynarski83 at gmail dot com 73 Al W7SYK

Its an older design. I installed a K2550 on AA6PW's TX-455 and it worked really well. I had to reverse the drum bolt and shim with washers. Its been going strong for over 10 years. Sent from my

That's odd...why on earth do they mount it sideways ?

Hello Jim! The correct cable is 7x19. The rest is spot on as usual. I only recommend SS if the owner can see sea water. Dino - KX6D Sent from my Verizon, Samsung Galaxy smartphone Get Outlook for

http://www.wd0m.com/winch.html

Hello...I'm looking for a few pictures of a us tower tx-455 with the HAND CRANK to raise it ...NOT THE TIP OVER....but the raise lower crank... Pictures of the crank installed with

7 strand, 1/4" EHS cable, like what's used on guyed towers with pre-form dead ends etc, is rated at 6700 lbs. 1/4" galvanized winch cable is rated at 5700 lbs. ( which I think is