Hello All! TL;DR: Long story short, I seem to have blown up the original Nano and need to replace it. The destroyed Nano may have taken out other things. For a little background, I'm an EE with a bit

I 3D printed a simple, snap on stand for my sBITX V2 for desktop use that leans it back 30 degrees for better viewing. The sides simply slide over the rear feet and are held in place by a small flange

I do not know how to get the source code files into a sketch with the ide. Can someone guide me? I want to use the CEC software. thanks, Paul K0ZYV

My sbitx pi is not maintaining time when powered off and not connected to the internet but utc is correct. Please advise

I'm working on a uBITX v6 basic kit that did not include a speaker. What would be a good-sounding and quality aftermarket speaker? I'm building the case around the speaker and a 3.5" Nextion display s

I have been noticing Encoder noise while tuning around the bands, I can see it in the waterfall and hear it in the receiver while tuning. Has anybody else noticed this? I might try installing some .1m

3 things 1. With sbitx connected to antenna and transmit I have rf noise on transmit audio 2. If I have if gain turned up above 35 I get 2 rf spikes in the same spot on the display all bands 3. If I h

Many have requested an sd card image as an alternative to upgrading the sbitx software. Upgrading the software is the recommended way to go as it preserves the personal settings, logbook etc. Using a

Hi all, is it possible to disable the webUI Chrome app on startup of the sBitx software? I only use the webUI on a remote computer. Thx

A few of you are probably familiar with my experiences with the DE version of the sBitx. There have been quite a number of different things happening which, by Occam’s razor, are in my opinion for the

Can someone point me to the board definition files and the Write library to use with the SWR/Power sensor in the Sbitx? The one board file that I did find is from DigiSpark. I can compile and load the

Hello Farhan and group Maybe a stupid question, where is the the S-Meter? I have not found it! Otherwise I like my new toy! 73 Patrick

Here they are, my uBitx V6, sBitx Developer's Edition and sBitx V2, all working beautifully. Thanks to all of you who gave tips and guidance along the way! What a great group. 73, Jack N6LN

Hi all, did anybody measured the AMR (absolute maximum range) for current consumption at full power please? Want to order proper bimetal thermo-switch for power line in V2. Tnx, -P #5

Hi. I need some help to fix the RX on my new sBitxv2 board. Since the first day I can't receive any signals. Even strong FT8 signals don't come through. I can see a weak signal in the waterfall displa

I purchased the sBITX earlier this month, website says about 5 days for delivery, is there any way to check the status of my order?

I looked here but could not find why my sBITx V2 radio won't power on, It has been working fine for just a week, I bought it at Hamvention. I was checking the output into a dummy load watt meter showe

The sBITX version 2 sounds like a great rig on paper and I would very much like to buy one, but this forum is such a mish mash of overlapping issues poorly identified that it is very difficult to dete

Just a reminder we now have a Discord. We have almost 70 people in there now. https://discord.gg/vKYQSqudQJ

I am unable to find a description of what the "function" knob does when it is pushed. I did notice that if I used a mouse to change the RF gain that the function knob would only change the RF gain unl