Try removing the SD card then put in PC and delete bad TFT file.

You should have a directory labeled ubitx_20 and inside this folder should look like this pic. Open ubitx_20.ino and compile. Vince

Did you check the micro switch to be sure it isn't always closed? Vince

#ubitx #ubitx-help

I saw the S meter firmware but wasn't sure what it was about. Got it. Thanks.

Super. Thanks.

I am using Nextion so using I2C. I should have mentioned Nextion in original email. Thanks, Vince

Thanks Evan. No, I had not seen this. I think I found it here http://www.nd6t.com/bitx/S%20meter.htm. A2 is A2 on the Nano or Pin 2 on the Analog Raduino connector which seems to be Pin 3 for A2 on th

Good Morning, I am having difficulty activating the S Meter. I have it checked in Memory Manager V1.11 and have tried several different number configurations along with S Meter box checked and nothing

Now that is funny. Good one!!

Have you tried Memory Manager to see if anything changes? I had problems at first because my changes didn't seem to take. What I did: Power off Ubitx and connect USB cable from Ubitx to PC Start Memor

Thanks Gary. Vince

Good Afternoon, My UBitX V3 was working fine and I decided to install the Nextion display using ubitx_lcd_nextion.ino. All seems to work fine but I am unable to receive any stations. I am using A3 Bea

I just tried this on removing a 64 pin SMD chip and it worked fantastic. Have had Chipquik for a while but never used. Worked GREAT!!! THANKS!!! 73 Vince N1VIN

Did you do the following from hfsignals? "µBITX Tuneup The µBITX comes pre-aligned. You should do this only if you really think it is out of alignment. There are three things to be tuned up. 1. PA BIA

HFSignals says available June 2

Done. Thanks, Vince N1VIN

I'd be in. Vince N1VIN

Hey Ed, You've got 7 years on me but I have assembled Bitx40 and UBitX and QRP-Labs U3S. The most difficult part of both was putting them in a case. Assembling the radios was quite easy with minimal s

I use a piece of the small tubing like they use in aquariums. 1/8" ID and 1/4" OD.

I'd be very interested Nick. I can paypal whenever you are ready. Thanks, 73 Vince N1VIN