Follow Allisons instruction for the complete mod....you'll be glad you did. Maurice. Vk6hly

Mine isn't that fancy Wayne, I just did a cable swap

Solved! Thanks to all who helped. It turned out to be my manual antenna tuner not being able to tune in MW. I connected my antenna straight in to my ubitx and all those MW broadcast stations came to l

Dean, I tried your demo but no luck. Still won't tune down that far. I will have a look around memory manager next chance I get. Thanks Maurice

Sorry Dean that method does not work for mine.

Yup found that one out the hard way Evan

You may have given me a clue Evan. I have tried a couple of earlier versions of the firmware. I think i may have been using the version which included an audio tone for calibration at the time. So I'm

Evan I am using CEC v1.2. yes I am trying to tune into 720khz. It's our local ABC. Maurice

Hi Evan, I forgot to mention in my post but all other bands rx and tx work just fine. I'm sure I tried to zero beat 720 back when I was calibrating my V5. Just not receiving MW any longer. Maurice.

My V5 is not receiving our local am broadcast stations ie 720 882 etc. I'm fairly sure I could receive them in the past. They are on air as confirmed with my hf Kenwood rig. All other bands are workin

Hi again, I have suddenly discovered my V5 is not receiving our local am broadcast stations eg 720 882 etc. I am fairly positive it was before. I checked with my other Kenwood hf rig and the stations

Problem fixed! Decoupling the Mike wires with .01 caps was the answer. Thanks Lawrence for your wisdom. Dennis, You are correct, obviously some stray rf floating around. and Arv I didn't get around to

On Tue, Feb 4, 2020 at 4:36 PM, Maurice Bersan via Groups.Io <Vk6hly@...> wrote: Thanks Arv, decoupling at the moment but will try your idea if decoupleing fails. Maurice On Mon, Feb 3

Thanks Arv, decoupling at the moment but will try your idea if decoupleing fails. Maurice

Yes the cable is shielded....do you mean decouple all Mike leads to ground?

Thanks Dennis, I did try 2 snap on ferrites at various locations and did not make any difference at all. I find the curly cord is most sensitive at the Mike end. I just made up a new Mike cord using s

Gday folks, I have just discovered I have a sensitive mike cord, by that I mean if I touch it my version 5 goes into transmit or just sends a carrier. It only happens on certain frequencys mainly 80me

Morris, is this what your after? https://ubitx.com/2018/07/28/digital-adapter-board/

Raffaello, sorry about the name mix-up before. The only way I could get my bfo settings to stick was to do the calibration and bfo settings one after the other at the same time. Then when complete tur

Hardrain, sounds like you probably need to do a factory reset. Turn the radio off Then while pressing in and holding the tuning knob turn the power back on. Follow the on screen instructions. Sometime