It has sold :) Joel KD6AGW

Hi David, sorry, I’m not sure how the PM works on this board. just email me at jtrenalone@..., thanks, Joel KD6AGW

Hi David, I just sent you a PM. Let me know if you received it, joel

Yes :)

Greetings All, I’m selling my fully assembled UBITX V5 transceiver. It comes equipped with all of KD6CEC software and hardware upgrades (Nextion 2.8 screen, S-meter, SWR bridge and meter, and CW decod

oh....I failed to mention in inserted a .1 uf cap in the line attached to AFOUT (RB15).

Hello All, thought I’d share my success with a simple hookup. There are several ways to hook this up, and this is one that I can verify works well on the V5 board. I removed r70 on the advise of a gro

Hello Armando, if it is an amateurradiokits.in then they do have an issue with the V5 board. I had to grind off the bump in the case right underneath the board with the headphone connector so it would

#v5

Skip, thanks for the advice, as I was trying to figure out how to insert without scratching up the traces on the board. Great idea :)

Thanks for all the input. I put the power to the receive rail, so it now the filter is not powered during transmit. So not the RF feedback is gone. But....I can’t here the CW side tone now. After look

Thanks Dennis, the board is on the far left of the ubitx board. It’s not a big case so not much more room. I will replace the audio wire with shielded cables to see if it helps. Thanks Howard, Since y

Hello All, I have been slower adding features to my UBITX V5, and just inserted the Sotabeams Laserbeam CW in the high vol line before the volume pot. I added a .1 uf cap on the output of the filter o

Jerry and Tom, Thanks for the links and information. Each time I deal with an issue like this I learn a bit more. Here is a pic of my setup, solar charges battery operation. It’s really working great

Just to clarify, the test above is a test of the transmitter output with the SWR bridge inline (in) and bypassed (out), in response to Mark Hatch’s question :)

Also, here are the schematics for both the kitsandparts bridge (I’m using), and the home brew Stockton bridge (that Ian Lee uses in his video and description http://www.hamskey.com/2019/04/installing-

OK, I checked the output with the bridge in and out and there is no perceptible difference in power out (on the oscilliscope 10 volts per division, reading about 45 volts on each with a 50ohm dummy lo

For information, here is a sketch of what I did. The home brew Stockton bridge that Ian (CEC) used apparently did not have this problem.

Greetings All, I have been working on my UBiTx V5 for a few months now and have added KD8CEC update with nextion screen and the I2C update. I had all the features working (CW decode etc) except the SW

Greetings all, Same here. I assembled my UBITx about 6 months ago into the amateurradiokits.com (Sunil) and had to grind off the screw hole bumps on the bottom of the case, took me a while to figure o

OK, So after some heavy study of many posts and comment on Ian’s CEC blog page, i found exactly my question: ....,,So this replaces earlier versions of the s-meter using the LM386 or LM358 chip?? All