Michel, Why not simply add one of these programmed to 116mhz? https://www.qrp-labs.com/progrock.html Joel N6ALT

Getting a 404 error on your link OM. Joel N6ALT

Hi Chris, I had done several of the 'spurs' mods that were popular at the time to that radio before I sent it to you, it was putting out at least 10 watts on most bands and I used it it regularly to c

I bought the 2 meter version and used it for quite a while on 2 meter SSB, but it drifted a lot. I was going to replace the 116mhz crystal onboard to something more stable but never got motivated. Min

Scott, For years I've been using a free app for my iPhone called Tone Generator, it comes up outputting a 1000hz sine wave tone, I just put it by the mic and key up then make my tuner adjustments. It'

Good job Reed, It's all working good now, thanks. Joel N6ALT

#ubitx #nano #v6 #ubitxv6

Thanks Reed, Please don't take my complaint as being unappreciative, I as many others appreciate everything you do to make our uBitx's more usable. I will patiently wait. Joel N6ALT

#ubitx #nano #v6 #ubitxv6

Yes, I tried that but it appears that it no longer works in this update. Joel N6ALT

#ubitx #nano #v6 #ubitxv6

Reed, I now know what is going on. The calibration is so far off that the buttons no longer correspond to the actual locations. If I take a stylus and randomly poke around on the screen I can occasion

#ubitx #nano #v6 #ubitxv6

Reed, Interesting discovery, I have a spare Raduino with a touch screen on it, I uploaded the sketch onto that and I have the same problem as on my radio, no touch screen which points to the sketch. S

#ubitx #nano #v6 #ubitxv6

Hi Reed, I've been playing around with R1.4.0 and was going through checking my Calibration settings, when I got to 'Screen' I chased the x around the screen and then it just went blank, after a reboo

#ubitx #nano #v6 #ubitxv6

80, 40, and 20 meters. Joel N6ALT

Chris, I operated that radio on 13.8 volts for a year and it didn't blow up, I'm sure it will be alright. Joel N6ALT

Hi Reed, I have been using your tweaked code for some time now and find it very usable, however if it's at all possible please make future versions have the ability to disable or adjust the speed of t

#ubitx #v6

Looks good Chris, How well does it receive? I'm with Gordon and Mark, you will no doubt have problems with that setup do to the fact that the legs of your dipole are tied up to other wires. The SWR wi

#antennas #v3

Good news Chris! It never hurts to have the landlords blessing. I hope it all works out out. Joel N6ALT

#antennas #v3

Chris, I also would recommend a half wave end fed. The QRP Guys https://qrpguys.com/qrpguys-end-fed-wire-antenna is the perfect comb for your uBitx, all you need is some cheap wire. I have found cheap

#antennas #v3

No problems with my antennas or my radio, works fine now. Thanks anyway. Joel N6ALT

#v6

If any desire to add a amp as I did you might want to remove C75, a 1mfd cap across pins 1 and 8 of the LM386 chip, this will lower the gain of that chip from 200 to 20 which makes the audio noise flo

#v6

I decided that I would go another direction for my low audio problem, instead of trying to insert a preamp I just am using the uBitx's audio amp as the preamp to a TDA2030 module, it works so much bet

#v6