John I am thinking that you correctly adjusted the bfo, since you are now receiving nicely. If you go to 20m, select usb, it should also receive well. This is because ubitx does a spectrum flip, there

#calibration #v6 #ssb

Well guys, this is going to give you a good chance to begin to understand more and more about Radio! If you don’t hear the tone until you are tuned 2kHz off, then yes your radio is a fair bit out of c

#calibration #ssb

Thanks! That solves the (more or less) final issue I have with the radio that I'd take the time to deal with - exactly what I needed and wanted to know! I don't think I'm going to change the firmware,

#ssb #bitx40

deadline for papers: March 18th submissions and questions to: conferencepapers@... Call for Papers and Presentations for the second VHF Super Conference, April 26-28, 2019, in Sterli

#2meters #6meters #antennas #ft8 #ssb

Take a pic and share of your L5/7 area. Raj

#ssb

Hi there. First off : please don't start a "Hifi @ssb" discussion, this is not my Intention. I am using a Behringer Q802USB audio mixer and a Behringer C1 dynamic microphone and went for the mixer bec

#ubitx #ssb

The kitsandparts.com multiPIG+ receiver used a variable 5 pole Cohn filter. I built and measured one of these and found that as designed the passband was initially rather poor as you tuned for larger

#ubitxcw #cw #ssb

Clarification Please: I have version 4 uBitx Board. My primary mode is SSB. What bands, if any, are currently tested passable for SSB mode?

#ssb #filters #ubitx #ubitx-help

Symptom: SSB audio is unreadable. When tuning the VFO, SSB signals are heard "off-frequency" then the audio "goes away" as the frequency gets closer to the correct frequency. Solution: Perform the BFO

#ubitx #calibration #ssb

Thanks, Evan, I'm getting closer. I did in fact verify that I have +12v (or so) into the mic element when PTT is held. I thought that bias was there all the time, but your explanation covers that. (I'

#ssb #v5 #tx

Hi I have measurement the Q12 transistor and the results are below in receive mode C,B,E it was 0Volt in transmit mode it was C=13,2 volt B=2,4 volt E=0 volt Maybe something going wrong with Q12.

#bitx40 #bitx40help #ssb