Clarification Please: I have version 4 uBitx Board. My primary mode is SSB. What bands, if any, are currently tested passable for SSB mode?

#ssb #filters #ubitx #ubitx-help

Call for Papers and Presentations for the second Super VHF Conference, April 26-28, 2019, in Sterling, VA, near Washington, DC. The the second Super VHF Conference is jointly sponsored by Packrats, NE

#2meters #6meters #antennas #ft8 #ssb

Hi there. First off : please don't start a "Hifi @ssb" discussion, this is not my Intention. I am using a Behringer Q802USB audio mixer and a Behringer C1 dynamic microphone and went for the mixer bec

#ubitx #ssb

Howdy y'all! I got my ubitx v4 a while ago. Finally wired it up, fired it up, put on the Nextion display and firmware and it all worked out of the box! What a slick gizmo. (And kudos to the folks who

#ssb

I've finally gotten the noise problem with my BitX-40 down to where it's not too bad, and I think with some additional work, I can eliminate the little is left. My setup: BitX-40 with homemade bugcatc

#ssb #bitx40

Hi - Just completed my ubitx 5 build and it passed the first power on test (yay!). The controls appear to work as intended. CW sounds pretty good to my years. SSB phone audio is garbled and difficult

#calibration #ssb

Symptom: SSB audio is unreadable. When tuning the VFO, SSB signals are heard "off-frequency" then the audio "goes away" as the frequency gets closer to the correct frequency. Solution: Perform the BFO

#ubitx #calibration #ssb

Dear uBITX enthusiasts. recently my uBitx transceiver has been finished. I find this project ufb because it is an excellent learning platform for me. As with many others, a number of modifications are

#ubitxcw #cw #ssb

Hi All: I just got back into Ham radio after about 20 years and recently upgraded to General in the last couple of weeks and at the same time received a ubitx v6. Last night I put up an inverted V dip

#calibration #v6 #ssb

I'm ironing out the kinks and my v5 is coming together. If I can knock this one out then I'll be ready to go out and do some operating! My TX is good and strong on CW. Waveform seems nicely shaped (to

#ssb #v5 #tx

hello, My bitx40 not transmit when use mic but when use CW transmit normally and my output power is 5watt on dummy load. please any idea about my problem. 73 de Yiannis, SV5FRI

#bitx40 #bitx40help #ssb