JJ1EPE Maybe it is related to the side tone. Check the side tone of ICOM Transceiver and the side tone of uBITX. Set 'Shift Display Frequency on CWL, CWU Mode' in uBITX Manager software. Probably

Andy I will check if you send me your uBITX backup file. You can back up your uBITX settings to a file in uBITX Manager. Send it to me Simply put, the order is as follows. Connect -> Read from uBITX

Micheal Are you using 1.094 Beta with Nextion LCD? Version 1.094 with Nextion LCD has not yet implemented this. Implemented in version 1.095. Version 1.095 is now ready for release. (Supported from

Hi Peter. Will you sell boards? or share Gerbers? Thanks Nick VK4PLN

Len, the enclosure is metallic from amateur radio kits in India, so it should be well shielded.

Hi Nick, I will make the final Gerbers available along with all the relevant information to enable the PCB's to be manufactured, I'll also share the circuit diagram and a board overlay in PDF so it

lan and everyone who replied me I did not use uBITX manager. But I have understood that using uBITX manager is essential to set CW offset and for uBITX. Now everything has been cleared by setting

Ian, at which address do you send a copy of the settings?

Hi Len, From a unusually hot uk. My both my ubitx versions 3 and 4.3 are both in plastic cases and I have not encountered any problems on

Hello everyone I am interested in version 3.5 because I already have the Nextion. Thanks a lot to Allen Merrell and everyone involved, especially Ian Lee. Michel F1GTX

I added the v4 pop-fix to my v3 board by placing components directly onto the v3 board. Start by drilling a small hole (0.7mm in my case) to the right of R70 so as to be able to fix the 2N7000

Forgot to mention, I also swapped out R70 from 100 ohms to 1K. Nigel.

I tried a couple of fans from old PC supplies. They were all very noisy. What I did to solve the problem was to put a resistor (maybe 10 ohms; don't remember and not taking the radio apart) in series

Good stuff. Just put one together myself. A little separate breadboard which I used a small portion so as to have room for another mod or two. Installing the Nextion 3.2 tomorrow. Love the ability to

Hi, I want to expand the amount of digital and analog I/O pins available to add enhancements to my uBITX. To do that I created a Smart LCD Backpack to replace the commonly found ones on the

Ian : Yes I am currently using V1.094 beta with the Nextion 2.8" Display. I will upgrade to V1.095 and try that. Cheers Michael VE3WMB

I am very much looking forward to your blog, Akira-san. Please kindly post the URL here at this BITX20 ML. Many thanks in advance. // hiro, JJ1FXF 2018/07/03 18:07、jj1epe@...のメール:

Tried another uBitxr4 board and had the same problem. I recommend this mod for everyone. Solder the pot and ZERO it and at lowvolume with the band background noise increase the preset and you will

Hi Arv, Thanks for reporting back the results of your experiment. I am thinking that you are going after a 'simple' solution where the fan doesn't run continuously. For micro-controller control, I

I am currently using Xloader up update firmware 1.08. Has been uploading for over an hour. I do see numbers changing on uBitX screen ie e6:f0e4e4e4. Should it take this long or am I missing