Hi Burçak, I'd contact support@... for help with this. They are very helpful and should be able to help and solve the problem. Regards, Jonas Den tis 13 okt. 2020 kl 10:31 skrev Burçak Çubukçu

Hi Aaron, The aluminium case is the Hammond 1455T1601 which is a nice size, but really a tight fit for the uBitx. The board need to sit sideways (I have Radiuno on right side and IRF510 on left side),

Gerard, I have one of these installed in one of my v4 uBITX. It works very well. As others have said, you will need to be careful with earphones, as it can generate a very high sound level. I have

My tracking code is RN190061493IN Still waiting for my uBitx since march Please help. Thanks, de TA2EE Burçak Cubukcu

Evan, I ordered the amplifiers. (5 modules for 10 euros!!! + free shipping) so only 2 euros per module. I’ll have them in less than 4 days. Thanks Jeff! Another question on use. On the Nextion and

Mick, Be very careful. With a strong signal, the TDA2030 can deliver a full 20 watts directly to your ear drum. Unless you are using a reliable AGC, you risk ruining your hearing. - f

Mitchel, you are correct the schematic shows the cap then the resistors but on the board it is resistor then cap. Barry

I installed the TDA 2030 audio amp for my speaker connection. It works very well. I use headphones normally and I don’t need the extra volume for them. The TDA has a volume pot on it so you can

The voltage off the emitter ranges from zero to about 7volts.

Evan, I made the change this afternoon for pop This cuts the sound well when I switch to TX, but as soon as we return to RX there is always a noise as if a capacitor were draining. This noise is lower

Vic, Your case is pretty sharp. One thing I love about the uBitX and BitX is the creativity. You can find 500 IC7300 or KX3 and they will all pretty much look and operate the same. You can find 10

Give it a try. It should work fine on 3.5. It just won't use the whole screen. -- Dennis WC8C

on the print I have for the V6, R37 and C32 from Q32 are reversed, typo ?

Jonas, I like the aluminum case, the 3-d printed one looks cool. Is the Makita powering the UBitX? I also have the N7DDC Tuner for the UBitX. I don't have it finished yet, I am making a case for it

For some reason, the XLoader kept telling me that the upload was a failure. Then I changed the comport to COM1 then switched it back to COM8 and it uploaded perfectly. I have the uBITX back together.

how much of AGC range are you getting out of the emitter degeneration arrangement? A different approach maybe to use a series diode. - f

Hi, Here the tuning section I wrote for the ubitx_v4.3_code.ino: if (s > 6) frequency += 1250l; else if (s > 2) frequency += 100l; else if (s > 0) frequency += 10l;

My solution to a slight noise problem was to use a small toroid and wrap the 4 nextion leads through it. I run a nextion 3.5 on my ubitx without additional regulator. Added in a heat sink to the

Gordon, Would you like to understand the function of each "KTx" relay, which selection each "KT" relay corresponds to? I also want to improve them. Congratulations on your changes. 73's Rubens py2pvb

Gordon, I would like to understand the function of each "KTx" relay, as I also want to improve them. Congratulations on your changes. 73's Rubens py2pvb