Yep, it does. Some idiots read the posts here (e.g., me) and simply cut-and-paste the URL and expect it to work. That's not always the case. Jack, W8TEE

This works http://www.hamskey.com/ Art N2AJO

You dont have enough attenuation for proper measurement. The fundamental as fed into the spectrum analyser should be -30bdm. Which would indicate about 70 db of attenuation. Stronger signals can

Jack, I checked, and HamsKey.com takes you to the current blog from Dr. Lee, so not directly to the KD8CEC software. There are so many options and features that have been added that I thought going

Bad URL?? Jack, W8TEE

Try reducing power by a watt or two and see. If the harmonics dropsignificantly then I'd say the PA is being over driven a bit. The power you are getting at the low bands is less than I would

The hex I loaded was the one Reed posted in message # 75440. I still have the stock screen and it works fine. My next step it to get a better mic going ..... just waiting on plugs to arrive. After

I did some baseline measurements on my new V6 running Reed's FW before I start changing too many things. The power's a good bit lower than expected and the third harmonics on both 15m and

Freeing up the code space that is required for the stock display allows for more features to be implemented. The KD8CEC software also allows additional controllers to be added for things like spectra

I would assume that there is an instruction in the Nextion code that allows reading and writing to that I/O without going through the Nano controller. You could put temperature warnings or special

That makes sense, hummm so what good is the ribbon cable for just like a hdmi input or something, I haven't seen anything hooked to a nextion ribbon ever.

Display is more sophisticated, offloads processing to the screens own subsystem vs having the arduino have to take on the workload, trying to keep up with more sophisticated screen renderings.

Well, it is an early release i usually take a few weks between me and raj to sort out thr bugs. Im this case, i was making incremental tweaks for sometime and then i realized that the software was

From the description supplied in support case the digital pins via the ribbon cable are not compatible with serial communication, as such are not wired to each other in anyway since the other side

Why not just use your ohm meter and prob the connector while touching the pin on other side Id imagine you would get continuity on the corresponding pins??

Reply to Nextion ticket.... Sorry, Schematic is not available. RX/TX is not mapped to Nextion GPIO GPIO is for digital signal allowing - input binding to Nextion component on page. - input read

Mine got stuck too! Sent 23/3/20 from HF Sigs.. Arrived yesterday at my UK QTH 18/6/20. Its Corona lockdowns fault sorry, I believe India was in total lockdown, but anything ordered from overseas at

Here is a file on how to use the KD8CEC software with the v6 ubitx. You doneed to change out the screen, as the KD8CEC software does not work with the stock screen. If you want touch and graphics,

Hi KF4ZGZ, I have a very recent ubitx v6 running the stock 6.1 software with the 2.8" TFT. I tried to get the KD8CEC sketch to work, but after trying all the display settings available, I could only

I suppose I can try and search and replace the usage of the touch and D_C in the HMI file to a Digital pin equivalent on the ribbon cable. Anyone who is more familiar with the HMI agree this is the