concise answer many thank dave c

Hello David, Maybe I made a mistake when I ordered the AGC print and mounted it in my UBITx V5.0. I am not satisfied with ho wit works/ or not works…If I look tot his printed circuit I see

You don't have to modify the encoder. Just add an SPST Normally Open pushbutton switch and connect the two wires from the second switch to the wires that go to the two separate pins on the encoder.

We've added NO push button switches to use as a selection object instead of the built-in switch. You still need to track which menu option level/option was selected (e.g., a State machine), but it's

has anyone modified the encoder so as to insert a separate switch to overide the need to push the encoder to select menus etc many thanks dave c

Thanks Ed and Curt, these are exactly what I needed. I don’t know what visual block did this but I was searching all over ubitx.net for instructions on the LED hookup and Curt’s comment made me

Put me down for a couple of BITX AGC boards. When ready K6KWQ Sent from Mail for Windows 10

Wow, not sure why the relay boards were slow to sell, either v3 and v4 folk could care less about spurs, or lots have done axicom surgery. Don't take by advice on kit marketing potential. Thanks

Hello all, We just put the Bitx40 AGC out to fab for proto type and look forward to having this ready in the coming weeks it will install just like our uBitx agc pre-built with install

hello, You can monitor your AF intput with this device . You can tap directly at the input from the mike plug though a 600/600 transformer and in serie with a 10nf capacitor. vu meter 73s

Is it as simple as adding the(appropriate) resister in series with the meter + side and ground the meter - side? And where would I tap the a V4 board for the resister going to the + meter? Don Km4udx

Would this count? Jack, W8TEE

Big fan of analog meters. For bitx levels and especially in SDRs—to balance the chi. ;-)

I used a round file and once the paint is gone inside the led hole it’s a tight fit, but no chance of it falling out. Ed N7SNT

Hello, Many options are possible to tune your AF level. obviously measurement tools like ocsilloscope tap directly at the output of the Af Amplifier or a spectrum analyzer is also very useful. in

I see the info at ubitx.com run by Sunil. See the category 2 construction ubitx case. Click on the picture. It takes you to page with more pictures, one shows where 3 wires are soldered to bottom of

I just finished my kit today too, smoke test passed. I have the Mic port and a couple things waiting on my antenna, but I’m very happy with the radio as well as Sunil’s case. The LED is where

I had previewed a raspberry pi board for hf radios with a high end codec at the fdim. This is for a new radio that i am building to push the limits of what my homelab capability can produce. Pictures

They solder to bottom of the main board. The enclosure should have several papers describing this, or go to Sunil's website, may be ubitx.com to locate where to solder the wires. I then touched the

That's awesome. I just picked up a 'like new' Collins power supply cabinet for a KWM-2 series radio at a hamfest. I am thinking seriously about a similar build, with a uBitx mounted inside, but hadn't