many thanks!

"Bet you write the file using a Mac. Macs writes extra files to the sd card. Believe it has a “.” Prefix but has the “.tft” suffix. That is what is causing the multiple tft file error." OK

Lo l, I am no expert. I use win7. Yes mac is popular. . Is it possible to rename file extention of unwanted file to serve your cause

Wrong, Curt. Presence of that Tuning connector defines your board as BITX40 - and yes, Shep, that extra 3-pin connector on board was for the potentiometer to control the voltage of a varicap diode in

On Sat, 5 Oct 2019, 9:45 am Mvs Sarma, <mvssarma@...> wrote: Econd phto is here. The resistor faced other sude. Hence you see white background. You can silder normal 1/4w resistor across those

Econd phto is here. The resistor faced other sude. Hence you see white background. You can silder normal 1/4w resistor across those leads. ✌

Bet you write the file using a Mac. Macs writes extra files to the sd card. Believe it has a “.” Prefix but has the “.tft” suffix. That is what is causing the multiple tft file error. Been

You can see the 8 pin connector marked"P1" Place resistor between pins 2 and 3 as counted from end of 16pin lcd connector. I placed smd 0805 , that too at a vertical angle. Let me show it. Obviously

On the sd card that loads tft there should only be one file. Nothing else. Transfer all other chunk into a folder on your laptop for use later. Perhaps that is what the message meant. Kd8cec also

Dumb question on the G4HUP buffer install... since this is attached into the receive side of the bidi amplifier, am I correct in understanding that this will not be adversely affected during transmit?

Hello I just got my U-bitx together. I used the Amateur radio kits case kit. I had trouble with my encoder wiring so I cut the wires off of the plugs that came with the kit and soldered them directly

Use your BITX! Come and have some fun, this Sunday! An easy one from

...if they share the same file name. Jack, W8TEE

Usually this message indicates that you have two libraries that share the same name. This is especially likely when you have the same libraries, but for different processors (e.g., an Arduino Nano and

Try removing the SD card then put in PC and delete bad TFT file.

When I try to update the proper file, the display reads, "The system detects multiple tft files, files can not be upgraded. Please remove extra ftf file.

No need to delete. Loading a new file removes older one, if i am not wrong.

Hello, I have the wrong file loaded in my Nextion. How do I delete the bad file? The does not give me a option to delete a file when I try to upload the proper file. Thanks Scott

Check your wiring visually and with a dvm, to confirm you have no short nor open in supplying dc voltage. Is this a ubitx? That 4.7k resistor is necessary for proper ssb ptt and for CW. It will

I’m trying to calculate my calibration value in order to calibrate my Ver 5 uBITx, using CEC Firmware ver. 1.200 because I can’t get a good signal from WWV. Like Ian, I set the frequency on