Hi Ian, My display is a basic version. Unfortunately, I did not know the limitation of the basic units.. I originally purchased it for my Raspberry Pi 3 B+. That may also explain the difficulty I had

I am using the 2.8 Nextion. Initially I had cut the opening to fit the glass surface and then noticed not just that the surface had unused area, but more important the illuminating LED was shining

Hi Eric, Are you using the enhanced version.The basic version won't work.A tft file can be copied directly to a married card and installed but the basic version of the ft will return a error Get

I’m very new to all this but I’ve twice had the no audio except for encoder clicks. First time I found that I had actually lost RF input due to a faulty BNC antenna connector. Wiggling the coax

turn down the RV1 - f

Newbie to uBitx and at 74 years young new to arduino also. I have a V5 ubitx. Having trouble calibrating frequency & BFO. I can adjust the frequency listening to another receiver and I can adjust the

Newbie to uBitx and at 74 years young new to arduino also. I have a V5 ubitx. Having trouble calibrating frequency & BFO. I can adjust the frequency listening to another receiver and I can adjust the

Hi, as mentioned first symptoms was the sudden drop in audio to near nothing after an attempt to wire audio to the mike plug ( second round four pin connector) for digital use. All was working fine

Sam Confused here. You said you do not have an oscope, so what is it that is making weird lines? If injecting audio at the mixer output did not produce audio at the regular output then you have

I will try to help. Since I have not been following your specific thread, can you bring me up to speed. The topic indicates you are using a V5 uBITX. What have you tried thus far? Did it ever

My v4 is a bit below 5w on 40m, but I digress. First, consider accuracy of your power meter. I won't swear my wm2 is perfect. Some instruments seem to over estimate power a bit. Possibly your v5

Ian i actually took the extreme step of mounting a 1.5a 7805 on the case. And then I ran some wires to the Raduino (removing the original one). Had no choice since the 5” Nextion draws 500ma.

Tried injecting audio. No go. I might have to venture before the mixer. I'm lost on this one

I have an upcoming qrp sprint that had a max of 5w for ssb. Is there an easy way to back the power output down to this and back after the two hours? I am running a v5 bitx with the updated firmware

No audio at all now. Is there no longer any help available? Please !

Definitely will share it! However, may be a few months.... After I complete the screen work, I have to go after fixing the spurs and harmonics, then AGC, then amp, then maybe JackAl. My todo list is

Sam, can you fill us in on what test equipment you have? I would start by measuring voltages on the RX tags listed in th3 schematic. I would then try supplying a signal to the audio section

Mark, please share your ESP32 circuit when ready. Thanks

Sam Difficult to troubleshoot remotely without more information, but if there is no local oscillator signal into the BFO mixer there would be no audio output from that stage. You might connect your

I tried isolating the amp only. Nothing. I tried a radio shack amplified speaker on just the audio section of the main board...pre and post amp. Nothing. I tried isolating only the front panel.